When i connect my 500GB seagate HD on a P5020DS, its not getting mounted. This is the dmesg log; am i supposed to change some configuration ?
/ # dmesg usb 1-1: new high speed USB device using fsl-ehci and address 5 usb 1-1: configuration #1 chosen from 1 choice scsi2 : SCSI emulation for USB Mass Storage devices usb-storage: device found at 5 usb-storage: waiting for device to settle before scanning do_scsi_scan_host scsi 2:0:0:0: Direct-Access Seagate Expansion 0219 PQ: 0 ANSI: 6 sd 2:0:0:0: Attached scsi generic sg0 type 0 usb 1-1: USB disconnect, address 5 sd 2:0:0:0: [sda] the result = 65536 usb-storage: device scan complete sd 2:0:0:0: [sda] sense_valid = 0 sd 2:0:0:0: [sda] the result = 65536 sd 2:0:0:0: [sda] sense_valid = 0 sd 2:0:0:0: [sda] the result = 65536 sd 2:0:0:0: [sda] sense_valid = 0 *sd 2:0:0:0: [sda] READ CAPACITY failed* sd 2:0:0:0: [sda] Result: hostbyte=0x01 driverbyte=0x00 sd 2:0:0:0: [sda] Sense not available. sd 2:0:0:0: [sda] Write Protect is off sd 2:0:0:0: [sda] Mode Sense: ea 0d 20 84 sd 2:0:0:0: [sda] Assuming drive cache: write through sd 2:0:0:0: [sda] the result = 65536 sd 2:0:0:0: [sda] sense_valid = 0 sd 2:0:0:0: [sda] the result = 65536 sd 2:0:0:0: [sda] sense_valid = 0 sd 2:0:0:0: [sda] the result = 65536 sd 2:0:0:0: [sda] sense_valid = 0 *sd 2:0:0:0: [sda] READ CAPACITY failed * sd 2:0:0:0: [sda] Result: hostbyte=0x01 driverbyte=0x00 sd 2:0:0:0: [sda] Sense not available. sd 2:0:0:0: [sda] Assuming drive cache: write through sd 2:0:0:0: [sda] Attached SCSI disk / # / # / # -- VISUAL --
_______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev
