Enable USB2 controller node for P1020RDB. USB2 controller is used only
when board boots from SPI or SD as it is muxed with eLBC
Signed-off-by: Ramneek Mehresh <ramneek.mehr...@freescale.com>
---
Applies on git://git.kernel.org/pub/scm/linux/kernel/git/galak/powerpc.git
(branch next)
arch/powerpc/boot/dts/p1020rdb.dtsi | 11 ++++-------
1 files changed, 4 insertions(+), 7 deletions(-)
diff --git a/arch/powerpc/boot/dts/p1020rdb.dtsi
b/arch/powerpc/boot/dts/p1020rdb.dtsi
index b5bd86f..17559c4 100644
--- a/arch/powerpc/boot/dts/p1020rdb.dtsi
+++ b/arch/powerpc/boot/dts/p1020rdb.dtsi
@@ -1,7 +1,7 @@
/*
* P1020 RDB Device Tree Source stub (no addresses or top-level ranges)
*
- * Copyright 2011 Freescale Semiconductor Inc.
+ * Copyright 2011-2012 Freescale Semiconductor Inc.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions are met:
@@ -192,15 +192,12 @@
phy_type = "ulpi";
};
- /* USB2 is shared with localbus, so it must be disabled
- by default. We can't put 'status = "disabled";' here
- since U-Boot doesn't clear the status property when
- it enables USB2. OTOH, U-Boot does create a new node
- when there isn't any. So, just comment it out.
+ /* USB2 is shared with localbus. It is used
+ only in case of SPI and SD boot after
+ appropriate device-tree fixup done by uboot */
usb@23000 {
phy_type = "ulpi";
};
- */
mdio@24000 {
phy0: ethernet-phy@0 {
--
1.7.1
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
