I've got a custom 460SX board with PLX gen2 (8616) switches. When u-boot comes up everything is fine and my switches are indicating they are in Gen2 PCIe mode. If I let it boot my linux kernel (denx 2.6.36.1), boot almost immediately, the LEDs on my switches start to blink indicating they have are now at Gen1 speed. I've turned on debug in ppc4xx_pci.c but don't see anything obvious. As far as when it happens, it looks like the last message to the console is "uncompressing kernel" and then the LEDs start blinking. seems that it indicates it is very early. I've also tried removing all the PCIe from the device tree, but that did not matter.
In the data sheet it indicates that PEDSRn_RCEI can change the advertised rate. I've disabled that in the code, but it did not make any difference. I am just not sure where things are getting switched over. Any help would be appreciated. best ayman _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev
