Thomas Taranowski wrote: > Yes, I tried pretty much all combinations of boot order, but I believe > the preferred approach is to boot the agents first, then the host > according to my freescale documentation. My problem was that all > three devices had the same device id. Once I programmed them with > different device id's via the alternate device id register I could > finally get doorbell messages across with the jtag. In the current fsl_rio implementation initialization enables ACCEPT_ALL mode for the port therefore you should not have problems caused by initial destID value. Based on your post about multiport support I think you are close to find a source of the problem.
Are you using any switches in your setup or this is pure board-to-board configuration? Alex. _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev
