>> Hi Gary, >> >> According to the errata, it looks like the MPC8358 is subject to >> erratum QE_UART6. You'll need to use soft UART mode and load the >> microcode patch. Once that is done you will also need to use two >> different BRG's, one for tx and one for rx, since the soft UART mode >> microcode patch requires them to be set to different rates (I believe >> Rx is 16*baud under soft UART mode, and Tx is 1*baud). > > As I feared! Can you tell me where/how to get the microcode patch? > >> Also, I don't know if it matters or not, but you should change your >> dts entry "ser...@4000" to "ser...@2200", just like you recently changed >> your "reg =" to 0x2200. > > I did that as soon as I sent this and saw the glaring inconsistency :-) > > Thanks
Sure. Go to opensource.freescale.com/firmware and download (for your MPC8358) the 8360 soft UART mode microcode patch. You will need to know if your CPU is a 2.0 or 2.1 silicon, since there is a different microcode patch for each. Then in the kernel config I believe I included CONFIG_FW_LOADER and CONFIG_HOTPLUG (one of those may have autoselected the other). Make sure in your ucc_uart.c driver that soft uart mode is enabled. At boot time, the driver will kick off a 10 second timer that will expect the microcode patch to be loaded before the end of that 10 secs. Very early in my boot sequence, I have a startup script send the microcode patch file to the driver through the firmware-loading sysfs entry. But you need to be aware that the UCC number in the sysfs path will be offset by one. Since you are using UCC3, you should use a '2' in the path as shown below. This sequence worked for me (I changed the number for you to '2' in my command sequence, since I use a different UCC): echo 1 > /sys/class/firmware/fsl-ucc-uart2/loading cat /root/fsl_qe_ucode_uart_8360_21.bin > /sys/class/firmware/fsl-ucc-uart2/data echo 0 > /sys/class/firmware/fsl-ucc-uart2/loading Note that the above presupposes you are using the file for silicon 2.1. Also presupposes that you have put the microcode under your rootfs /root directory. Chuck Meade ch...@theptrgroup.com _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev