Benjamin Herrenschmidt wrote:
On Thu, 2010-02-25 at 07:25 -0700, Gary Thomas wrote:
I may have been too hasty pronouncing this fixed. Indeed, the
SATA interface now works, but my video card (Fujitsu Coral-P)
does not work when it's mapped at the bottom of the PCI space :-(
With the bridge mapped, the video ends up at a non-zero address
(0xC8000000..0xCFFFFFFF). If it gets mapped to 0xC0000000, it
fails to respond to MMIO accesses.
Any ideas how I might get around this? Is there a way to force
the PCI allocator to start somewhere other than [relative] zero?
I'm not familiar with the way the FSL bridge works, but it would
be possible to invert MMIO and DMA on your PCI bus. IE. Have MMIO go
from 0....2G and DMA from 2G..4G for example. Provided the FSL bridge
can offset the DMA back down to 0 (memory). Can it ?
It can, but I don't see how that would help, if the problem is that the
video card doesn't like the low 30 bits of its MMIO address being zero.
Gary, can you check that the MMIO addresses are going to the PCI bus
as-is, and aren't being translated down to zero? I.e. POTARn should
equal POBARn, and likewise in the device tree's pci node's ranges.
-Scott
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
