We had merged the 2.6.24 with the FSL based NAND driver, we observed that 
gpio library is mandatory to be included. We have not included the gpios 
configured in the dts file as the we don’t have the separate GPIO 
chip(arch/powepc/boot/dts/board.dts). 
 After executing the image in the board, we observed the below
1)      The device ID and manufacture Id was printed as "c0" and "c0" and the 
error message "No NAND device found!!!".  Does it mean it is not accessing the 
NAND flash and the values read are junk one?
2)      Processor of the board doesn’t connect the Ready/Busy of the NAND flash 
through the separate GPIO chip. I mean it is directly connected from GPIO Port 
C of PIN 15 to the Ready/Busy PIN of the NAND flash. Hence is it necessary to 
port the gpio specific functions like gpio_request/gpio_free(specified in 
fsl_upm.c file), instead should we need to configure the PIN 
par_io_config_pin()  for configuration of the PORT C with 15th PIN and set the 
data value using par_io_data_set() (specified 
arch/powerpc/sysdev/qe_lib/qe_io.c)

Please let me know any input on the above issue.

Thanks in advance

Regards,
Nanda
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev

Reply via email to