Old method only set tbi-phy for eth0.
Signed-off-by: Liu Yu <yu....@freescale.com>
---
drivers/net/ucc_geth.c | 23 +++++++++++++++--------
1 files changed, 15 insertions(+), 8 deletions(-)
diff --git a/drivers/net/ucc_geth.c b/drivers/net/ucc_geth.c
index 750d86d..0e72013 100644
--- a/drivers/net/ucc_geth.c
+++ b/drivers/net/ucc_geth.c
@@ -37,6 +37,7 @@
#include <asm/qe.h>
#include <asm/ucc.h>
#include <asm/ucc_fast.h>
+#include <asm/machdep.h>
#include "ucc_geth.h"
#include "fsl_pq_mdio.h"
@@ -1334,7 +1335,7 @@ static int adjust_enet_interface(struct ucc_geth_private
*ugeth)
struct ucc_geth __iomem *ug_regs;
struct ucc_fast __iomem *uf_regs;
int ret_val;
- u32 upsmr, maccfg2, tbiBaseAddress;
+ u32 upsmr, maccfg2;
u16 value;
ugeth_vdbg("%s: IN", __func__);
@@ -1389,14 +1390,20 @@ static int adjust_enet_interface(struct
ucc_geth_private *ugeth)
/* Note that this depends on proper setting in utbipar register. */
if ((ugeth->phy_interface == PHY_INTERFACE_MODE_TBI) ||
(ugeth->phy_interface == PHY_INTERFACE_MODE_RTBI)) {
- tbiBaseAddress = in_be32(&ug_regs->utbipar);
- tbiBaseAddress &= UTBIPAR_PHY_ADDRESS_MASK;
- tbiBaseAddress >>= UTBIPAR_PHY_ADDRESS_SHIFT;
- value = ugeth->phydev->bus->read(ugeth->phydev->bus,
- (u8) tbiBaseAddress, ENET_TBI_MII_CR);
+ struct ucc_geth_info *ug_info = ugeth->ug_info;
+ struct phy_device *tbiphy;
+
+ if (!ug_info->tbi_node)
+ ugeth_warn("TBI mode requires that the device "
+ "tree specify a tbi-handle\n");
+
+ tbiphy = of_phy_find_device(ug_info->tbi_node);
+ if (!tbiphy)
+ ugeth_warn("Could not get TBI device\n");
+
+ value = phy_read(tbiphy, ENET_TBI_MII_CR);
value &= ~0x1000; /* Turn off autonegotiation */
- ugeth->phydev->bus->write(ugeth->phydev->bus,
- (u8) tbiBaseAddress, ENET_TBI_MII_CR, value);
+ phy_write(tbiphy, ENET_TBI_MII_CR, value);
}
init_check_frame_length_mode(ug_info->lengthCheckRx, &ug_regs->maccfg2);
--
1.6.4
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
