On Jul 13, 2009, at 7:49 PM, FUJITA Tomonori wrote:
On Mon, 13 Jul 2009 16:50:43 -0500
Becky Bruce <bec...@kernel.crashing.org> wrote:
talked about defining something like struct dma_data. Then we could
struct dev_archdata {
...
struct dma_data *ddata;
};
or
struct dev_archdata {
...
struct dma_data ddata;
};
struct dma_data needs dma_direct_offset, iommu_table, dma_base, and
dma_window_size, anything else?
IIRC, what we had talked about was simpler - we talked about changing
the current dev_archdata from this:
struct dev_archdata {
struct device_node *of_node;
struct dma_mapping_ops *dma_ops;
void *dma_data;
};
to this:
struct dev_archdata {
struct device_node *of_node;
struct dma_mapping_ops *dma_ops;
unsigned long long dma_data;
#ifdef CONFIG_SWIOTLB
dma_addr_t max_direct_dma_addr;
#endif
};
Where max_direct_dma_addr is the address beyond which a specific
device must use swiotlb, and dma_data is the offset like it is now
(but wider on 32-bit systems than void *). I believe Ben had
mentioned
wanting to make the max_direct_dma_addr part conditional so we don't
bloat archdata on platforms that don't ever bounce.
Only maximum address is enough? The minimum (dma_window_base_cur in
swiotlb_pci_addr_needs_map) is not necessary?
The change to the type of dma_data is actually in preparation for an
optimization I have planned for 64-bit PCI devices (and which
probably
requires more discussion), so that doesn't need to happen now - just
leave it as a void *, and I can post a followup patch.
Let me know if I can help or do any testing - I've been meaning to
look into switching to dma_map_ops for a while now but it hasn't
managed to pop off my todo stack.
Ok, how about this? I'm not familiar with POWERPC so I might
misunderstand something.
This is close, but it misses the setup for non-pci devices. We have a
bus notifier that we use to set up archdata for those devices -
ppc_swiotlb_bus_notify() in arch/powerpc/kernel/dma-swiotlb.c. It
won't cause breakage to not have this set up, because those will fall
through to the dma_capable(), but I think we should initialize it
anyway (who knows what it will end up used for later....).
diff --git a/arch/powerpc/include/asm/device.h b/arch/powerpc/
include/asm/device.h
index 7d2277c..0086f8d 100644
--- a/arch/powerpc/include/asm/device.h
+++ b/arch/powerpc/include/asm/device.h
@@ -16,6 +16,9 @@ struct dev_archdata {
/* DMA operations on that device */
struct dma_mapping_ops *dma_ops;
void *dma_data;
+#ifdef CONFIG_SWIOTLB
+ dma_addr_t max_direct_dma_addr;
+#endif
};
static inline void dev_archdata_set_node(struct dev_archdata *ad,
diff --git a/arch/powerpc/include/asm/swiotlb.h b/arch/powerpc/
include/asm/swiotlb.h
index 30891d6..b23a4f1 100644
--- a/arch/powerpc/include/asm/swiotlb.h
+++ b/arch/powerpc/include/asm/swiotlb.h
@@ -24,4 +24,6 @@ static inline void dma_mark_clean(void *addr,
size_t size) {}
extern unsigned int ppc_swiotlb_enable;
int __init swiotlb_setup_bus_notifier(void);
+extern void pci_dma_dev_setup_swiotlb(struct pci_dev *pdev);
+
#endif /* __ASM_SWIOTLB_H */
diff --git a/arch/powerpc/kernel/dma-swiotlb.c b/arch/powerpc/kernel/
dma-swiotlb.c
index 68ccf11..e21359e 100644
--- a/arch/powerpc/kernel/dma-swiotlb.c
+++ b/arch/powerpc/kernel/dma-swiotlb.c
@@ -56,39 +56,16 @@ swiotlb_arch_address_needs_mapping(struct device
*hwdev, dma_addr_t addr,
size_t size)
{
struct dma_mapping_ops *dma_ops = get_dma_ops(hwdev);
+ struct dev_archdata *sd = &hwdev->archdata;
BUG_ON(!dma_ops);
- return dma_ops->addr_needs_map(hwdev, addr, size);
-}
You can get rid of the dma_ops stuff here.... it's no longer needed.
-/*
- * Determine if an address is reachable by a pci device, or if we
must bounce.
- */
-static int
-swiotlb_pci_addr_needs_map(struct device *hwdev, dma_addr_t addr,
size_t size)
-{
- u64 mask = dma_get_mask(hwdev);
- dma_addr_t max;
- struct pci_controller *hose;
- struct pci_dev *pdev = to_pci_dev(hwdev);
-
- hose = pci_bus_to_host(pdev->bus);
- max = hose->dma_window_base_cur + hose->dma_window_size;
-
- /* check that we're within mapped pci window space */
- if ((addr + size > max) | (addr < hose->dma_window_base_cur))
+ if (sd->max_direct_dma_addr && addr + size > sd-
>max_direct_dma_addr)
return 1;
- return !is_buffer_dma_capable(mask, addr, size);
-}
-
-static int
-swiotlb_addr_needs_map(struct device *hwdev, dma_addr_t addr,
size_t size)
-{
return !is_buffer_dma_capable(dma_get_mask(hwdev), addr, size);
}
-
/*
* At the moment, all platforms that use this code only require
* swiotlb to be used if we're operating on HIGHMEM. Since
@@ -104,7 +81,6 @@ struct dma_mapping_ops swiotlb_dma_ops = {
.dma_supported = swiotlb_dma_supported,
.map_page = swiotlb_map_page,
.unmap_page = swiotlb_unmap_page,
- .addr_needs_map = swiotlb_addr_needs_map,
.sync_single_range_for_cpu = swiotlb_sync_single_range_for_cpu,
.sync_single_range_for_device = swiotlb_sync_single_range_for_device,
.sync_sg_for_cpu = swiotlb_sync_sg_for_cpu,
@@ -119,13 +95,23 @@ struct dma_mapping_ops swiotlb_pci_dma_ops = {
.dma_supported = swiotlb_dma_supported,
.map_page = swiotlb_map_page,
.unmap_page = swiotlb_unmap_page,
- .addr_needs_map = swiotlb_pci_addr_needs_map,
.sync_single_range_for_cpu = swiotlb_sync_single_range_for_cpu,
.sync_single_range_for_device = swiotlb_sync_single_range_for_device,
.sync_sg_for_cpu = swiotlb_sync_sg_for_cpu,
.sync_sg_for_device = swiotlb_sync_sg_for_device
};
+void pci_dma_dev_setup_swiotlb(struct pci_dev *pdev)
+{
+ struct pci_controller *hose;
+ struct dev_archdata *sd;
+
+ hose = pci_bus_to_host(pdev->bus);
+ sd = &pdev->dev.archdata;
+ sd->max_direct_dma_addr =
+ hose->dma_window_base_cur + hose->dma_window_size;
+}
+
static int ppc_swiotlb_bus_notify(struct notifier_block *nb,
unsigned long action, void *data)
{
diff --git a/arch/powerpc/platforms/85xx/mpc8536_ds.c b/arch/powerpc/
platforms/85xx/mpc8536_ds.c
index 055ff41..401751b 100644
--- a/arch/powerpc/platforms/85xx/mpc8536_ds.c
+++ b/arch/powerpc/platforms/85xx/mpc8536_ds.c
@@ -136,6 +136,7 @@ define_machine(mpc8536_ds) {
.init_IRQ = mpc8536_ds_pic_init,
#ifdef CONFIG_PCI
.pcibios_fixup_bus = fsl_pcibios_fixup_bus,
+ .pci_dma_dev_setup = pci_dma_dev_setup_swiotlb,
#endif
.get_irq = mpic_get_irq,
.restart = fsl_rstcr_restart,
diff --git a/arch/powerpc/platforms/85xx/mpc85xx_ds.c b/arch/powerpc/
platforms/85xx/mpc85xx_ds.c
index 849c0ac..1ba8e38 100644
--- a/arch/powerpc/platforms/85xx/mpc85xx_ds.c
+++ b/arch/powerpc/platforms/85xx/mpc85xx_ds.c
@@ -277,6 +277,7 @@ define_machine(mpc8544_ds) {
.init_IRQ = mpc85xx_ds_pic_init,
#ifdef CONFIG_PCI
.pcibios_fixup_bus = fsl_pcibios_fixup_bus,
+ .pci_dma_dev_setup = pci_dma_dev_setup_swiotlb,
#endif
.get_irq = mpic_get_irq,
.restart = fsl_rstcr_restart,
@@ -291,6 +292,7 @@ define_machine(mpc8572_ds) {
.init_IRQ = mpc85xx_ds_pic_init,
#ifdef CONFIG_PCI
.pcibios_fixup_bus = fsl_pcibios_fixup_bus,
+ .pci_dma_dev_setup = pci_dma_dev_setup_swiotlb,
#endif
.get_irq = mpic_get_irq,
.restart = fsl_rstcr_restart,
@@ -305,6 +307,7 @@ define_machine(p2020_ds) {
.init_IRQ = mpc85xx_ds_pic_init,
#ifdef CONFIG_PCI
.pcibios_fixup_bus = fsl_pcibios_fixup_bus,
+ .pci_dma_dev_setup = pci_dma_dev_setup_swiotlb,
#endif
.get_irq = mpic_get_irq,
.restart = fsl_rstcr_restart,
diff --git a/arch/powerpc/platforms/85xx/mpc85xx_mds.c b/arch/
powerpc/platforms/85xx/mpc85xx_mds.c
index 60ed9c0..165a2de 100644
--- a/arch/powerpc/platforms/85xx/mpc85xx_mds.c
+++ b/arch/powerpc/platforms/85xx/mpc85xx_mds.c
@@ -356,6 +356,7 @@ define_machine(mpc8568_mds) {
.progress = udbg_progress,
#ifdef CONFIG_PCI
.pcibios_fixup_bus = fsl_pcibios_fixup_bus,
+ .pci_dma_dev_setup = pci_dma_dev_setup_swiotlb,
#endif
};
@@ -377,5 +378,6 @@ define_machine(mpc8569_mds) {
.progress = udbg_progress,
#ifdef CONFIG_PCI
.pcibios_fixup_bus = fsl_pcibios_fixup_bus,
+ .pci_dma_dev_setup = pci_dma_dev_setup_swiotlb,
#endif
};
diff --git a/arch/powerpc/platforms/86xx/mpc86xx_hpcn.c b/arch/
powerpc/platforms/86xx/mpc86xx_hpcn.c
index 6632702..d1878f3 100644
--- a/arch/powerpc/platforms/86xx/mpc86xx_hpcn.c
+++ b/arch/powerpc/platforms/86xx/mpc86xx_hpcn.c
@@ -187,5 +187,6 @@ define_machine(mpc86xx_hpcn) {
.progress = udbg_progress,
#ifdef CONFIG_PCI
.pcibios_fixup_bus = fsl_pcibios_fixup_bus,
+ .pci_dma_dev_setup = pci_dma_dev_setup_swiotlb,
#endif
};
Instead of initializing this here (which has problems if !
CONFIG_SWIOTLB), place this in the xxxxx_xxxx_setup_arch function in
the same files, which already have an #ifdef CONFIG_SWIOTLB in which
this can be embedded.
I'm about to be off-list for a few days but will be happy to help when
I'm back next week.
Thanks!
Becky
--
To unsubscribe from this list: send the line "unsubscribe linux-
kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
