Hi, I am trying to get a 2.6.27.6 kernel to boot on an MPC8568E processor. The kernel/patches/compiler came from Freescale's LTIB release in December 2008. Using the same kernel source, toolchain, and ramdisk image, I can boot and run an SMP kernel on the MPC8572E processor which is on the same board. This is what I see on the 8568E processor:
... brd: module loaded loop: module loaded fsl_pm.ko: loading ... fsl_pm.ko: no SoC node, ignoring fsl_pm.ko: hal initialisation Gianfar MII Bus: probed eth0: Gianfar Ethernet Controller Version 1.4-skbr1.1.4, 00:80:4d:22:00:66 eth0: MTU = 1500 (frame size=1524, truesize=1800) eth0: Running with NAPI enabled eth0: 128/128 RX/TX BD ring size eth1: Gianfar Ethernet Controller Version 1.4-skbr1.1.4, 00:80:4d:22:40:66 eth1: MTU = 1500 (frame size=1524, truesize=1800) eth1: Running with NAPI enabled eth1: 128/128 RX/TX BD ring size mice: PS/2 mouse device common for all mice i2c /dev entries driver EDAC MC: Ver: 2.1.0 Feb 9 2009 TCP cubic registered NET: Registered protocol family 17 RPC: Registered udp transport module. RPC: Registered tcp transport module. RAMDISK: Compressed image found at block 0 VFS: Mounted root (ext2 filesystem). Freeing unused kernel memory: 144k init Bad trap at PC: 100b7354, SR: 2d000, vector=2020 init has generated signal 5 but has no handler for it Kernel panic - not syncing: Attempted to kill init! Rebooting in 180 seconds.. I am not using a debugger, so I can't see where the SIGTRAP would be coming from. Thanks in advance, Scott ___________________________________________________________________ Scott N. Coulter Senior Software Engineer Cyclone Microsystems 370 James Street Phone: 203.786.5536 ext. 118 New Haven, CT 06513-3051 Email: scott.coul...@cyclone.com U.S.A. Web: http://www.cyclone.com ___________________________________________________________________ _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
