TSEC0 is connected to Vitesse 7385 5-port switch. The switch
isn't connected to any mdio bus, the link to the switch is fixed
to Full-duplex 1000 Mb/s (no pause).
This patch fixes following failure during bootup:
m...@24520:01 not found
eth0: Could not attach to PHY
IP-Config: Failed to open eth0
Signed-off-by: Anton Vorontsov <avoront...@ru.mvista.com>
---
arch/powerpc/boot/dts/mpc8313erdb.dts | 9 ++-------
arch/powerpc/configs/83xx/mpc8313_rdb_defconfig | 2 +-
2 files changed, 3 insertions(+), 8 deletions(-)
diff --git a/arch/powerpc/boot/dts/mpc8313erdb.dts
b/arch/powerpc/boot/dts/mpc8313erdb.dts
index 3f84cd0..3ebf7ec 100644
--- a/arch/powerpc/boot/dts/mpc8313erdb.dts
+++ b/arch/powerpc/boot/dts/mpc8313erdb.dts
@@ -191,7 +191,8 @@
interrupts = <37 0x8 36 0x8 35 0x8>;
interrupt-parent = <&ipic>;
tbi-handle = < &tbi0 >;
- phy-handle = < &phy1 >;
+ /* Vitesse 7385 isn't on the MDIO bus */
+ fixed-link = <1 1 1000 0 0>;
fsl,magic-packet;
m...@24520 {
@@ -199,12 +200,6 @@
#size-cells = <0>;
compatible = "fsl,gianfar-mdio";
reg = <0x24520 0x20>;
- phy1: ethernet-...@1 {
- interrupt-parent = <&ipic>;
- interrupts = <19 0x8>;
- reg = <0x1>;
- device_type = "ethernet-phy";
- };
phy4: ethernet-...@4 {
interrupt-parent = <&ipic>;
interrupts = <20 0x8>;
diff --git a/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig
b/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig
index 9e47ae9..409d017 100644
--- a/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig
+++ b/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig
@@ -651,7 +651,7 @@ CONFIG_CICADA_PHY=y
# CONFIG_NATIONAL_PHY is not set
# CONFIG_STE10XP is not set
# CONFIG_LSI_ET1011C_PHY is not set
-# CONFIG_FIXED_PHY is not set
+CONFIG_FIXED_PHY=y
# CONFIG_MDIO_BITBANG is not set
CONFIG_NET_ETHERNET=y
CONFIG_MII=y
--
1.5.6.5
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
