On Wed, Nov 18, 2026 at 12:00:20PM +0100, Vincent Jardin via B4 Relay wrote:
> From: Vincent Jardin <[email protected]>
> 
> IIC7 and IIC8, the i2c6 and i2c7 nodes, exist only on the SDHC2_DAT[7:4]
> pads, and one RCW field, SDHC2_DAT74_PMUX, muxes all four of them:
>  - 0b010 gives both buses
>  - 0b001 gives GPIO2[18:15]
> 
> Both nodes point at the same two pin states of that field. A board that
> enables one of the two buses gets a working bus recovery from them, so
> they stay in the SoC dtsi.
> 
> A board that enables both cannot use them: the pinctrl core gives the
> field to the first controller and the second one fails to probe, and
> the bus recovery of one would switch the pads of the other one to GPIO
> too. Say so above each node.
> 
> Suggested-by: Vladimir Oltean <[email protected]>
> Link: https://lore.kernel.org/all/[email protected]/
> Signed-off-by: Vincent Jardin <[email protected]>
> ---

Reviewed-by: Vladimir Oltean <[email protected]>

Reply via email to