Of these: 7 "for a while" typos 5 "take a while" typos 1 misreading of "once in a while"?
3 awhiles used correctly remain in the tree
Signed-off-by: Ahelenia Ziemiańska <nabijaczlew...@nabijaczleweli.xyz>
---
Documentation/trace/histogram.rst | 2 +-
arch/sh/drivers/pci/common.c | 2 +-
arch/sh/drivers/pci/pci-sh7780.c | 2 +-
drivers/atm/lanai.c | 2 +-
drivers/md/bcache/bcache.h | 2 +-
drivers/md/bcache/request.c | 2 +-
drivers/net/ethernet/google/gve/gve_rx_dqo.c | 2 +-
drivers/scsi/hpsa.c | 2 +-
drivers/tty/serial/jsm/jsm_neo.c | 2 +-
fs/ocfs2/dlm/dlmrecovery.c | 2 +-
sound/pci/emu10k1/emu10k1_main.c | 2 +-
sound/pci/emu10k1/emupcm.c | 2 +-
tools/testing/selftests/powerpc/tm/tm-tmspr.c | 2 +-
13 files changed, 13 insertions(+), 13 deletions(-)
diff --git a/Documentation/trace/histogram.rst
b/Documentation/trace/histogram.rst
index 0aada18c38c6..2b98c1720a54 100644
--- a/Documentation/trace/histogram.rst
+++ b/Documentation/trace/histogram.rst
@@ -249,7 +249,7 @@ Extended error information
table, it should keep a running total of the number of bytes
requested by that call_site.
- We'll let it run for awhile and then dump the contents of the 'hist'
+ We'll let it run for a while and then dump the contents of the 'hist'
file in the kmalloc event's subdirectory (for readability, a number
of entries have been omitted)::
diff --git a/arch/sh/drivers/pci/common.c b/arch/sh/drivers/pci/common.c
index 9633b6147a05..f95004c67e6c 100644
--- a/arch/sh/drivers/pci/common.c
+++ b/arch/sh/drivers/pci/common.c
@@ -148,7 +148,7 @@ unsigned int pcibios_handle_status_errors(unsigned long
addr,
cmd |= PCI_STATUS_PARITY | PCI_STATUS_DETECTED_PARITY;
- /* Now back off of the IRQ for awhile */
+ /* Now back off of the IRQ for a while */
if (hose->err_irq) {
disable_irq_nosync(hose->err_irq);
hose->err_timer.expires = jiffies + HZ;
diff --git a/arch/sh/drivers/pci/pci-sh7780.c b/arch/sh/drivers/pci/pci-sh7780.c
index 9a624a6ee354..f41d6939a3d9 100644
--- a/arch/sh/drivers/pci/pci-sh7780.c
+++ b/arch/sh/drivers/pci/pci-sh7780.c
@@ -153,7 +153,7 @@ static irqreturn_t sh7780_pci_serr_irq(int irq, void
*dev_id)
/* Deassert SERR */
__raw_writel(SH4_PCIINTM_SDIM, hose->reg_base + SH4_PCIINTM);
- /* Back off the IRQ for awhile */
+ /* Back off the IRQ for a while */
disable_irq_nosync(irq);
hose->serr_timer.expires = jiffies + HZ;
add_timer(&hose->serr_timer);
diff --git a/drivers/atm/lanai.c b/drivers/atm/lanai.c
index 2a1fe3080712..0dfa2cdc897c 100644
--- a/drivers/atm/lanai.c
+++ b/drivers/atm/lanai.c
@@ -755,7 +755,7 @@ static void lanai_shutdown_rx_vci(const struct lanai_vcc
*lvcc)
/* Shutdown transmitting on card.
* Unfortunately the lanai needs us to wait until all the data
* drains out of the buffer before we can dealloc it, so this
- * can take awhile -- up to 370ms for a full 128KB buffer
+ * can take a while -- up to 370ms for a full 128KB buffer
* assuming everone else is quiet. In theory the time is
* boundless if there's a CBR VCC holding things up.
*/
diff --git a/drivers/md/bcache/bcache.h b/drivers/md/bcache/bcache.h
index 1d33e40d26ea..7318d9800370 100644
--- a/drivers/md/bcache/bcache.h
+++ b/drivers/md/bcache/bcache.h
@@ -499,7 +499,7 @@ struct gc_stat {
* won't automatically reattach).
*
* CACHE_SET_STOPPING always gets set first when we're closing down a cache
set;
- * we'll continue to run normally for awhile with CACHE_SET_STOPPING set (i.e.
+ * we'll continue to run normally for a while with CACHE_SET_STOPPING set (i.e.
* flushing dirty data).
*
* CACHE_SET_RUNNING means all cache devices have been registered and journal
diff --git a/drivers/md/bcache/request.c b/drivers/md/bcache/request.c
index af345dc6fde1..87b4341cb42c 100644
--- a/drivers/md/bcache/request.c
+++ b/drivers/md/bcache/request.c
@@ -257,7 +257,7 @@ static CLOSURE_CALLBACK(bch_data_insert_start)
/*
* But if it's not a writeback write we'd rather just bail out if
- * there aren't any buckets ready to write to - it might take awhile and
+ * there aren't any buckets ready to write to - it might take a while
and
* we might be starving btree writes for gc or something.
*/
diff --git a/drivers/net/ethernet/google/gve/gve_rx_dqo.c
b/drivers/net/ethernet/google/gve/gve_rx_dqo.c
index dcb0545baa50..6a0be54f1c81 100644
--- a/drivers/net/ethernet/google/gve/gve_rx_dqo.c
+++ b/drivers/net/ethernet/google/gve/gve_rx_dqo.c
@@ -608,7 +608,7 @@ static int gve_rx_dqo(struct napi_struct *napi, struct
gve_rx_ring *rx,
buf_len = compl_desc->packet_len;
hdr_len = compl_desc->header_len;
- /* Page might have not been used for awhile and was likely last written
+ /* Page might have not been used for a while and was likely last written
* by a different thread.
*/
if (rx->dqo.page_pool) {
diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c
index c73a71ac3c29..0066f15153a7 100644
--- a/drivers/scsi/hpsa.c
+++ b/drivers/scsi/hpsa.c
@@ -7795,7 +7795,7 @@ static int hpsa_wait_for_mode_change_ack(struct ctlr_info
*h)
u32 doorbell_value;
unsigned long flags;
- /* under certain very rare conditions, this can take awhile.
+ /* under certain very rare conditions, this can take a while.
* (e.g.: hot replace a failed 144GB drive in a RAID 5 set right
* as we enter this code.)
*/
diff --git a/drivers/tty/serial/jsm/jsm_neo.c b/drivers/tty/serial/jsm/jsm_neo.c
index e8e13bf056e2..2eb9ff26d6e8 100644
--- a/drivers/tty/serial/jsm/jsm_neo.c
+++ b/drivers/tty/serial/jsm/jsm_neo.c
@@ -1189,7 +1189,7 @@ static irqreturn_t neo_intr(int irq, void *voidbrd)
/*
* The UART triggered us with a bogus interrupt type.
* It appears the Exar chip, when REALLY bogged down,
will throw
- * these once and awhile.
+ * these periodically.
* Its harmless, just ignore it and move on.
*/
jsm_dbg(INTR, &brd->pci_dev,
diff --git a/fs/ocfs2/dlm/dlmrecovery.c b/fs/ocfs2/dlm/dlmrecovery.c
index 67fc62a49a76..00f52812dbb0 100644
--- a/fs/ocfs2/dlm/dlmrecovery.c
+++ b/fs/ocfs2/dlm/dlmrecovery.c
@@ -2632,7 +2632,7 @@ static int dlm_pick_recovery_master(struct dlm_ctxt *dlm)
dlm_reco_master_ready(dlm),
msecs_to_jiffies(1000));
if (!dlm_reco_master_ready(dlm)) {
- mlog(0, "%s: reco master taking awhile\n",
+ mlog(0, "%s: reco master taking a while\n",
dlm->name);
goto again;
}
diff --git a/sound/pci/emu10k1/emu10k1_main.c b/sound/pci/emu10k1/emu10k1_main.c
index bbe252b8916c..6050201851b1 100644
--- a/sound/pci/emu10k1/emu10k1_main.c
+++ b/sound/pci/emu10k1/emu10k1_main.c
@@ -606,7 +606,7 @@ static int snd_emu10k1_ecard_init(struct snd_emu10k1 *emu)
/* Step 2: Calibrate the ADC and DAC */
snd_emu10k1_ecard_write(emu, EC_DACCAL | EC_LEDN | EC_TRIM_CSN);
- /* Step 3: Wait for awhile; XXX We can't get away with this
+ /* Step 3: Wait for a while; XXX We can't get away with this
* under a real operating system; we'll need to block and wait that
* way. */
snd_emu10k1_wait(emu, 48000);
diff --git a/sound/pci/emu10k1/emupcm.c b/sound/pci/emu10k1/emupcm.c
index 1bf6e3d652f8..ca4b03317539 100644
--- a/sound/pci/emu10k1/emupcm.c
+++ b/sound/pci/emu10k1/emupcm.c
@@ -991,7 +991,7 @@ static snd_pcm_uframes_t snd_emu10k1_capture_pointer(struct
snd_pcm_substream *s
if (!epcm->running)
return 0;
if (epcm->first_ptr) {
- udelay(50); /* hack, it takes awhile until capture is
started */
+ udelay(50); /* hack, it takes a while until capture is
started */
epcm->first_ptr = 0;
}
ptr = snd_emu10k1_ptr_read(emu, epcm->capture_idx_reg, 0) & 0x0000ffff;
diff --git a/tools/testing/selftests/powerpc/tm/tm-tmspr.c
b/tools/testing/selftests/powerpc/tm/tm-tmspr.c
index dd5ddffa28b7..0d64988ffb40 100644
--- a/tools/testing/selftests/powerpc/tm/tm-tmspr.c
+++ b/tools/testing/selftests/powerpc/tm/tm-tmspr.c
@@ -14,7 +14,7 @@
* (1) create more threads than cpus
* (2) in each thread:
* (a) set TFIAR and TFHAR a unique value
- * (b) loop for awhile, continually checking to see if
+ * (b) loop for a while, continually checking to see if
* either register has been corrupted.
*
* (3) Loop:
--
2.39.5
signature.asc
Description: PGP signature
