On Thu, Sep 18, 2008 at 8:43 PM, Wolfgang Grandegger <[EMAIL PROTECTED]> wrote: > Li Yang-R58472 wrote: >>> -----Original Message----- >>> From: [EMAIL PROTECTED] >>> [mailto:[EMAIL PROTECTED] >>> On Behalf Of Wolfgang Grandegger >>> Sent: Wednesday, September 17, 2008 5:18 PM >>> To: linuxppc-dev >>> Subject: UCC GETH does not work on my MPC8360EA >>> >>> Hello, >>> >>> I have a wired problems with my MPC8360EA using Linux >>> 2.6.27-rc6. The UCC GEHT controller works fine with 100/Full >>> but fails with 1000/Full. >>> What I see is that the TX done interrupts come (ifconfig's TX >>> packet counter goes up), but the messages does not show up on >>> the wire. RX seems to work properly, though. >>> >>> Any idea what's going wrong? Does someone got it working with >>> 1000/Full? >> >> This looks like an old problem that RGMII Tx shouldn't use internal >> delay while Rx should use. So try to use 'rgmii-rxid' as >> phy-connection-type in device tree. Also there should have been a fixup >> in u-boot for this. So update to use latest u-boot might fix your >> problem. > > I do not have problems with U-Boot using 1000/full. The DTS property
I mean that the latest u-boot can fixup the phy-connection-type automatically base on the chip revision. - Leo _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
