During boot the kernel mounts the root file system and (I think) based on the
size of the NAND in
the dts attempts to "format" the rest of the NAND fs partition. At this point
the blocks are
being marked as bad. Therefore, when I reboot, the kernel thinks that there is
no more usable
space in the file system due to all the "bad" blocks. My dts is very similar
to the 8313.
I think the problem is that for the Large Page FLASH, when checking for bad
blocks bytes 0 and 1
in the oob are being checked. However in fsl_elbc_nand.c the .oobfree begins
at byte 1.
Therefore if something is being written to byte 1 in the oob, and later is
checked to see if the
block is bad, it will be seen as bad when it checks byte 0 and 1. The changes
below have worked
for me, but I don't know if these changes are "right", or if there is something
else that should
be done instead.
/* Large Page FLASH with FMR[ECCM] = 0 */
static struct nand_ecclayout fsl_elbc_oob_lp_eccm0 = {
.eccbytes = 12,
.eccpos = {6, 7, 8, 22, 23, 24, 38, 39, 40, 54, 55, 56},
- .oobfree = { {1, 5}, {9, 13}, {25, 13}, {41, 13}, {57, 7} },
+ .oobfree = { {2, 4}, {9, 13}, {25, 13}, {41, 13}, {57, 7} },
.oobavail = 48,
};
/* Large Page FLASH with FMR[ECCM] = 1 */
static struct nand_ecclayout fsl_elbc_oob_lp_eccm1 = {
.eccbytes = 12,
.eccpos = {8, 9, 10, 24, 25, 26, 40, 41, 42, 56, 57, 58},
- .oobfree = { {1, 7}, {11, 13}, {27, 13}, {43, 13}, {59, 5} },
+ .oobfree = { {2, 6}, {11, 13}, {27, 13}, {43, 13}, {59, 5} },
.oobavail = 48,
};
Ron
--- Scott Wood <[EMAIL PROTECTED]> wrote:
> Ron Madrid wrote:
> > I know I asked about this in the past, but I can't remember where it was
> > left. Did this get
> > resolved in some other repository that isn't the main linux-2.6 repository?
> > If it didn't I
> think
> > I might have a solution. BTW I'm using 2.6.26-rc8
>
> What was the issue?
>
> -Scott
>
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
