[NAND] driver extension to support NAND on TQM85xx modules
This patch extends the FSL UPM NAND driver from Anton Vorontsov to
support NAND on the TQM85xx modules. Unfortunately, the hardware does
not support the R/B pins of the NAND chip and therefore the specified
maximum delay time must used. It therefore re-introduces the chip-delay
property.
Note: this patch is based on various patches from Anton Vorontsov posted
to this list:
http://ozlabs.org/pipermail/linuxppc-dev/2008-April/055587.html.
http://ozlabs.org/pipermail/linuxppc-dev/2008-May/057158.html
http://ozlabs.org/pipermail/linuxppc-dev/2008-May/056531.html
http://ozlabs.org/pipermail/linuxppc-dev/2008-June/057244.html
They should show up mainstream soon.
Signed-off-by: Wolfgang Grandegger <[EMAIL PROTECTED]>
---
Documentation/powerpc/booting-without-of.txt | 1 +
drivers/mtd/nand/Kconfig | 2 +-
drivers/mtd/nand/fsl_upm.c | 17 +++++++++++++----
3 files changed, 15 insertions(+), 5 deletions(-)
Index: linux-2.6-galak/drivers/mtd/nand/Kconfig
===================================================================
--- linux-2.6-galak.orig/drivers/mtd/nand/Kconfig
+++ linux-2.6-galak/drivers/mtd/nand/Kconfig
@@ -380,7 +380,7 @@ config MTD_NAND_FSL_ELBC
config MTD_NAND_FSL_UPM
tristate "Support for NAND on Freescale UPM"
- depends on MTD_NAND && OF_GPIO && (PPC_83xx || PPC_85xx)
+ depends on MTD_NAND && (PPC_83xx || PPC_85xx)
select FSL_LBC
help
Enables support for NAND Flash chips wired onto Freescale PowerPC
Index: linux-2.6-galak/drivers/mtd/nand/fsl_upm.c
===================================================================
--- linux-2.6-galak.orig/drivers/mtd/nand/fsl_upm.c
+++ linux-2.6-galak/drivers/mtd/nand/fsl_upm.c
@@ -13,6 +13,7 @@
#include <linux/kernel.h>
#include <linux/module.h>
+#include <linux/delay.h>
#include <linux/mtd/nand.h>
#include <linux/mtd/nand_ecc.h>
#include <linux/mtd/partitions.h>
@@ -36,6 +37,7 @@ struct fsl_upm_nand {
uint8_t upm_cmd_offset;
void __iomem *io_base;
int rnb_gpio;
+ int chip_delay;
};
#define to_fsl_upm_nand(mtd) container_of(mtd, struct fsl_upm_nand, mtd)
@@ -58,10 +60,11 @@ static void fun_wait_rnb(struct fsl_upm_
if (fun->rnb_gpio >= 0) {
while (--cnt && !fun_chip_ready(&fun->mtd))
cpu_relax();
+ if (!cnt)
+ dev_err(fun->dev, "tired waiting for RNB\n");
+ } else {
+ ndelay(100);
}
-
- if (!cnt)
- dev_err(fun->dev, "tired waiting for RNB\n");
}
static void fun_cmd_ctrl(struct mtd_info *mtd, int cmd, unsigned int ctrl)
@@ -129,7 +132,7 @@ static int __devinit fun_chip_init(struc
fun->chip.IO_ADDR_R = fun->io_base;
fun->chip.IO_ADDR_W = fun->io_base;
fun->chip.cmd_ctrl = fun_cmd_ctrl;
- fun->chip.chip_delay = 50;
+ fun->chip.chip_delay = fun->chip_delay;
fun->chip.read_byte = fun_read_byte;
fun->chip.read_buf = fun_read_buf;
fun->chip.write_buf = fun_write_buf;
@@ -233,6 +236,12 @@ static int __devinit fun_probe(struct of
goto err2;
}
+ prop = of_get_property(ofdev->node, "chip-delay", NULL);
+ if (prop)
+ fun->chip_delay = *prop;
+ else
+ fun->chip_delay = 50;
+
fun->io_base = devm_ioremap_nocache(&ofdev->dev, io_res.start,
io_res.end - io_res.start + 1);
if (!fun->io_base) {
Index: linux-2.6-galak/Documentation/powerpc/booting-without-of.txt
===================================================================
--- linux-2.6-galak.orig/Documentation/powerpc/booting-without-of.txt
+++ linux-2.6-galak/Documentation/powerpc/booting-without-of.txt
@@ -3007,6 +3007,7 @@ platforms are moved over to use the flat
- reg : should specify localbus chip select and size used for the chip.
- fsl,upm-addr-offset : UPM pattern offset for the address latch.
- fsl,upm-cmd-offset : UPM pattern offset for the command latch.
+ - chip-delay : may specify a delay value in milliseconds.
- gpios : may specify optional GPIO connected to the Ready-Not-Busy pin.
Example:
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
