pSeries machines on POWER9 processors can run with the XICS (legacy)
interrupt mode or with the XIVE exploitation interrupt mode. These
interrupt contollers have different interfaces for interrupt
management : XICS uses hcalls and XIVE loads and stores on a page.
H_EOI being a XICS interface the enable_scrq_irq() routine can fail
when the machine runs in XIVE mode.
Fix that by calling the EOI handler of the interrupt chip.
Fixes: f23e0643cd0b ("ibmvnic: Clear pending interrupt after device reset")
Signed-off-by: Cédric Le Goater <c...@kaod.org>
---
drivers/net/ethernet/ibm/ibmvnic.c | 8 +++-----
1 file changed, 3 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/ibm/ibmvnic.c
b/drivers/net/ethernet/ibm/ibmvnic.c
index 2b073a3c0b84..f59d9a8e35e2 100644
--- a/drivers/net/ethernet/ibm/ibmvnic.c
+++ b/drivers/net/ethernet/ibm/ibmvnic.c
@@ -2878,12 +2878,10 @@ static int enable_scrq_irq(struct ibmvnic_adapter
*adapter,
if (test_bit(0, &adapter->resetting) &&
adapter->reset_reason == VNIC_RESET_MOBILITY) {
- u64 val = (0xff000000) | scrq->hw_irq;
+ struct irq_desc *desc = irq_to_desc(scrq->irq);
+ struct irq_chip *chip = irq_desc_get_chip(desc);
- rc = plpar_hcall_norets(H_EOI, val);
- if (rc)
- dev_err(dev, "H_EOI FAILED irq 0x%llx. rc=%ld\n",
- val, rc);
+ chip->irq_eoi(&desc->irq_data);
}
rc = plpar_hcall_norets(H_VIOCTL, adapter->vdev->unit_address,
--
2.21.0
