On Thursday 10 April 2008, M B wrote: > I'm porting vanilla 2.6.25-rc8 (arch=powerpc) to a new board. UART is > already working in the kernel and Uboot with UART and ethernet is also > working. > But I can't get the emac driver (ibm_newemac) working under Linux. > On boot emac_init get's called and exits normally, but no probe or > open will get called and no network devices (except lo) are known to > the kernel. > > Do I have to do something more, than adding the mals and emacs to the > device tree? I haven't seen any 40x or 44x board in the platforms > folder doing something special for the emac. > > Any hints?
How does your .config look? Please send the EMAC defines only. And send the emac/mal related dts nodes. And the current kernel boot log. Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] ===================================================================== _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
