Sergei Shtylyov wrote:
Valentine Barshak wrote:
This adds PCI entry to PowerPC 440EPx Sequoia DTS.
Signed-off-by: Valentine Barshak <[EMAIL PROTECTED]>
--- linux-2.6.orig/arch/powerpc/boot/dts/sequoia.dts 2007-12-21
17:14:17.000000000 +0300
+++ linux-2.6/arch/powerpc/boot/dts/sequoia.dts 2007-12-21
17:18:32.000000000 +0300
@@ -324,6 +324,33 @@
has-new-stacr-staopc;
};
};
+
+ PCI0: [EMAIL PROTECTED] {
+ device_type = "pci";
+ #interrupt-cells = <1>;
+ #size-cells = <2>;
+ #address-cells = <3>;
+ compatible = "ibm,plb440epx-pci", "ibm,plb-pci";
+ primary;
+ reg = <1 eec00000 8 /* Config space access */
+ 1 eed00000 4 /* IACK */
+ 1 eed00000 4 /* Special cycle */
+ 1 ef400000 40>; /* Internal registers */
+
+ /* Outbound ranges, one memory and one IO,
+ * later cannot be changed. Chip supports a second
+ * IO range but we don't use it for now
+ */
+ ranges = <02000000 0 80000000 1 80000000 0 10000000
I wonder why the AMCC's Sequoia/Rainier manual has PCI memory mapped
at 0x80000000-0xbfffffff? The 0x80000000-0x8fffffff mapping was assumed
by arch/ppc/ code. What/why changed here?
The addresses in the manual are relative to bus base. PCI controller is
located on the PLB and PLB base address is 0x100000000ULL on Sequoia.
Older PPC code has ioremap64 function that did the 64 to 32-bit trick
It's been abolished. The kernel has support for 64-bit physical
addresses on 32-bit. IMHO there's no big reason to keep doing that
address trick. However, there are some drivers that use unsigned long
for storing physical addresses. This is wrong, since
pci_resource_start() returns a resource_size_t value. I think it's these
drivers that have to be fixed instead of adding workarounds to ppc4xx code.
Thanks,
Valentine.
As we now both know, having PCI memory space mapped beyound 4 GB
makes some drivers misbehave as they use 'unsigned long' to store the
result of pci_resource_start() and later ioremap() this truncated value
-- which is 64-bit on Sequoia due to CONFIG_RESOURCE_64BIT=y that is
needed to store the beyond-4GB addresses.
+ 01000000 0 00000000 1 e8000000 0 00100000>;
+
+ /* Inbound 2GB range starting at 0 */
+ dma-ranges = <42000000 0 0 0 0 0 80000000>;
+
+ /* All PCI interrupts are routed to IRQ 67 */
+ interrupt-map-mask = <0000 0 0 0>;
+ interrupt-map = < 0000 0 0 0 &UIC2 3 8 >;
+ };
};
WBR, Sergei
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
