The Xilinx 16550 uart core is not a standard 16550 because it uses
word-based addressing rather than byte-based addressing. With
additional properties it is compatible with the open firmware
'ns16550' compatible binding.
This code updates the of_serial driver to handle the reg-offset
and reg-shift properties to enable this core to be used.
Signed-off-by: John Linn <[EMAIL PROTECTED]>
---
Documentation/powerpc/booting-without-of.txt | 11 +++++++++++
drivers/serial/of_serial.c | 15 +++++++++++++--
2 files changed, 24 insertions(+), 2 deletions(-)
diff --git a/Documentation/powerpc/booting-without-of.txt
b/Documentation/powerpc/booting-without-of.txt
index 87f4d84..af112d9 100644
--- a/Documentation/powerpc/booting-without-of.txt
+++ b/Documentation/powerpc/booting-without-of.txt
@@ -2539,6 +2539,17 @@ platforms are moved over to use the
flattened-device-tree model.
differ between different families. May be
'virtex2p', 'virtex4', or 'virtex5'.
+ iv) Xilinx Uart 16550
+
+ Xilinx UART 16550 devices are very similar to the NS16550 such that they
+ use the ns16550 binding with properties to specify register spacing and
+ an offset from the base address.
+
+ Requred properties:
+ - clock-frequency : Frequency of the clock input
+ - reg-offset : A value of 3 is required
+ - reg-shift : A value of 2 is required
+
More devices will be defined as this spec matures.
VII - Specifying interrupt information for devices
diff --git a/drivers/serial/of_serial.c b/drivers/serial/of_serial.c
index 2efb892..af9ed48 100644
--- a/drivers/serial/of_serial.c
+++ b/drivers/serial/of_serial.c
@@ -30,7 +30,7 @@ static int __devinit of_platform_serial_setup(struct
of_device *ofdev,
{
struct resource resource;
struct device_node *np = ofdev->node;
- const unsigned int *clk, *spd;
+ const unsigned int *clk, *spd, *reg_offset, *reg_shift;
int ret;
memset(port, 0, sizeof *port);
@@ -48,7 +48,18 @@ static int __devinit of_platform_serial_setup(struct
of_device *ofdev,
}
spin_lock_init(&port->lock);
- port->mapbase = resource.start;
+
+ reg_offset = of_get_property(np, "reg-offset", NULL);
+ reg_shift = of_get_property(np, "reg-shift", NULL);
+
+ if (!reg_offset)
+ port->mapbase = resource.start;
+ else
+ port->mapbase = resource.start + *reg_offset;
+
+ if (reg_shift)
+ port->regshift = *reg_shift;
+
port->irq = irq_of_parse_and_map(np, 0);
port->iotype = UPIO_MEM;
port->type = type;
--
1.5.2.1
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
