On Friday 28 March 2008, zechao wang wrote: > I'm failed when booting the board using NFS on AMCC PPC 405EP. > I think i have read the getting started guide carefully! > The tftp server and nfs server can works well. > And the firewall was disabled, too.
<snip> > U-Boot 1.2.0 (Jan 26 2008 - 18:50:29) > > CPU: AMCC PowerPC 405EP Rev. B at 266.666 MHz (PLB=133, OPB=66, EBC=66 > MHz) I2C boot EEPROM disabled > Internal PCI arbiter enabled > 16 kB I-Cache 16 kB D-Cache > Board: Bubinga - AMCC PPC405EP Evaluation Board Is this really an IBM/AMCC Bubinga board? > I2C: ready > DRAM: 64 MB > FLASH: 512 kB > NAND: 64 MiB > In: serial > Out: serial > Err: serial > Net: VT6122 You are using not the SoC EMAC here. Why not? Is this Via chip connected to the PCI bus? > You are welcom! > > Hit any key to stop autoboot: 0 > Link autonegation speed 100M bps full duplex > Using VT6122 device > TFTP from server 192.168.1.142; our IP address is 192.168.1.120 > Filename 'uImage'. > Load address: 0x200000 > Loading: ################################################################# > ################################################################# > ################################################################# > ################## > done > Bytes transferred = 1086219 (10930b hex) > Checking ... > Check1. Check2. ## Booting image at 00200000 ... > Image Name: Linux-2.6.19.2 > Created: 2008-03-25 11:15:51 UTC > Image Type: PowerPC Linux Kernel Image (gzip compressed) > Data Size: 1086155 Bytes = 1 MB > Load Address: 00000000 > Entry Point: 00000000 > Verifying Checksum ... OK > Uncompressing Kernel Image ... OK > Linux version 2.6.19.2 ([EMAIL PROTECTED]) (gcc version 4.0.0 (DENX ELDK 4.1 > 4.0.0)) #6 Tue Mar 25 19:15:48 CST 2008 IBM Bubinga port (MontaVista > Software, Inc. <[EMAIL PROTECTED]>) > Zone PFN ranges: > DMA 0 -> 16384 > Normal 16384 -> 16384 > early_node_map[1] active PFN ranges > 0: 0 -> 16384 > Built 1 zonelists. Total pages: 16256 > Kernel command line: root=/dev/nfs rw > nfsroot=192.168.1.142:/opt/eldk/ppc_4xx > ip=192.168.1.120:192.168.1.142:192.168.1.1::IOStation:eth0:off p0PID hash > table entries: 256 (order: 8, 1024 bytes) Warning: real time clock seems > stuck! > Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) > Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) > Memory: 62592k available (1764k kernel code, 428k data, 132k init, 0k > highmem) Mount-cache hash table entries: 512 > NET: Registered protocol family 16 > PCI: Probing PCI hardware > NET: Registered protocol family 2 > IP route cache hash table entries: 512 (order: -1, 2048 bytes) > TCP established hash table entries: 2048 (order: 1, 8192 bytes) > TCP bind hash table entries: 1024 (order: 0, 4096 bytes) > TCP: Hash tables configured (established 2048 bind 1024) > TCP reno registered > io scheduler noop registered > io scheduler anticipatory registered (default) > io scheduler deadline registered > io scheduler cfq registered > Generic RTC Driver v1.07 > Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled > serial8250: ttyS0 at MMIO 0x0 (irq = 0) is a 16550A > serial8250: ttyS1 at MMIO 0x0 (irq = 1) is a 16550A > RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize > loop: loaded (max 8 devices) > VIA Networking Velocity Family Gigabit Ethernet Adapter Driver Ver. 1.14 > Copyright (c) 2002, 2003 VIA Networking Technologies, Inc. > Copyright (c) 2004 Red Hat Inc. > eth0: VIA Networking Velocity Family Gigabit Ethernet Adapter > eth0: Ethernet Address: 00:01:02:03:04:87 Again, not the SoC EMAC here. > Found: AMD AM29LV040B > PPC40x-flash: Found 1 x8 devices at 0x0 in 8-bit bank > number of JEDEC chips: 1 > cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. > Creating 3 MTD partitions on "PPC40x-flash": > 0x00000000-0x00020000 : "reserved" > 0x00020000-0x00040000 : "env" > 0x00040000-0x00080000 : "u-boot" > TCP cubic registered > NET: Registered protocol family 1 > NET: Registered protocol family 17 > NET: Registered protocol family 15 > Velocity is AUTO mode > IP-Config: Guessing netmask 255.255.255.0 > IP-Config: Complete: > device=eth0, addr=192.168.1.120, mask=255.255.255.0, gw=192..168.1.1, > host=IOStation, domain=, nis-domain=(none), > bootserver=192.168.1.142, rootserver=192.168.1.142, rootpath= > Looking up port of RPC 100003/2 on 192.168.1.142 > eth0: Link autonegation speed 100M bps full duplex > TD structure errror TDindex=0 This seems to be an error message from the network driver. I don't know this Via driver, so can't help here. But this seems to be the problem. Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] ===================================================================== _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
