On Friday 22 February 2008, Josh Boyer wrote: > On Fri, 22 Feb 2008 09:32:12 +0100 > > Stefan Roese <[EMAIL PROTECTED]> wrote: > > 405EX(r) has SDR0_MFR[E0CS/E1CS] set after reset. This selects > > the internal loopback mode. Clear these bits so that both EMACs > > don't use loopback mode as default. > > > > Signed-off-by: Stefan Roese <[EMAIL PROTECTED]> > > --- > > I'm not sure if this should be done here in the board platform code, > > or in the newemac driver or perhaps in some code common for 405EX. > > > > Any thoughts on this welcome. > > Why isn't this done in U-Boot? Or is it done if the network interface > is used?
Correct. It's only done upon EMAC usage in U-Boot. So when booting completely from FLASH, EMAC in Linux is not working. Best regards, Stefan _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
