This commit results in boot stopping after the following messages.
Any additional information I could provide?
U-Boot 2010.12-svn19826 (Apr 24 2013 - 20:01:21)
CPU: P1014, Version: 1.0, (0x80f10110)
Core: E500, Version: 5.1, (0x80212151)
Clock Configuration:
CPU0:800 MHz,
CCB:400 MHz,
DDR:333.333 MHz (666.667 MT/s data rate) (Asynchronous), IFC:100 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Board: P1014RDB
SPI: ready
DRAM: 128 MiB
L2: 256 KB enabled
Using default environment
PCIe1: Root Complex of mini PCIe Slot, x1, regs @ 0xffe0a000
01:00.0 - 168c:abcd - Network controller
PCIe1: Bus 00 - 01
PCIe2: Root Complex of PCIe Slot, x1, regs @ 0xffe09000
03:00.0 - 168c:0033 - Network controller
PCIe2: Bus 02 - 03
In: serial
Out: serial
Err: serial
Net: initialization for Atheros AR8327/AR8328
eTSEC1
auto update firmware: is_auto_upload_firmware = 0!
Autobooting in 1 seconds
SF: Detected S25FL128S_64K with page size 256, total 16 MiB
16384 KiB S25FL128S_64K at 0:0 is now current device
SPI flash read successful
SPI flash read successful
## Booting kernel from Legacy Image at 02000000 ...
Image Name: Linux-4.9.0-rc0
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 2009549 Bytes = 1.9 MiB
Load Address: 01000000
Entry Point: 01000524
Verifying Checksum ... OK
## Flattened Device Tree blob at 03000000
Booting using the fdt blob at 0x3000000
Uncompressing Kernel Image ... OK
Loading Device Tree to 00ffa000, end 00ffffff ... OK
