In commit <8445a87f7092> ("powerpc/iommu: Remove the dependency
on EEH struct in DDW mechanism"), the PE address was replaced
with the PCI config address in order to remove dependency on EEH.
According to PAPR spec, firmware (pHyp or QEMU) should accept
"xxBBSSxx" format PCI config address, not "xxxxBBSS" provided
by the patch. Note that "BB" is PCI bus number and "SS" is the
combination of slot and function number.
This fixes the PCI address passed to DDW RTAS calls.
Fixes: 8445a87f7092 ("powerpc/iommu: Remove the dependency on EEH struct in DDW
mechanism")
Reported-by: Guilherme G. Piccoli <gpicc...@linux.vnet.ibm.com>
Signed-off-by: Gavin Shan <gws...@linux.vnet.ibm.com>
Tested-by: Guilherme G. Piccoli <gpicc...@linux.vnet.ibm.com>
---
arch/powerpc/platforms/pseries/iommu.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/powerpc/platforms/pseries/iommu.c
b/arch/powerpc/platforms/pseries/iommu.c
index b7dfc13..3e8865b 100644
--- a/arch/powerpc/platforms/pseries/iommu.c
+++ b/arch/powerpc/platforms/pseries/iommu.c
@@ -927,7 +927,7 @@ static int query_ddw(struct pci_dev *dev, const u32
*ddw_avail,
dn = pci_device_to_OF_node(dev);
pdn = PCI_DN(dn);
buid = pdn->phb->buid;
- cfg_addr = (pdn->busno << 8) | pdn->devfn;
+ cfg_addr = ((pdn->busno << 16) | (pdn->devfn << 8));
ret = rtas_call(ddw_avail[0], 3, 5, (u32 *)query,
cfg_addr, BUID_HI(buid), BUID_LO(buid));
@@ -956,7 +956,7 @@ static int create_ddw(struct pci_dev *dev, const u32
*ddw_avail,
dn = pci_device_to_OF_node(dev);
pdn = PCI_DN(dn);
buid = pdn->phb->buid;
- cfg_addr = (pdn->busno << 8) | pdn->devfn;
+ cfg_addr = ((pdn->busno << 16) | (pdn->devfn << 8));
do {
/* extra outputs are LIOBN and dma-addr (hi, lo) */
--
2.1.0
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
