Hi everyone,
I am writing a serial port driver for ppc board. I am facing a very strange
problem. I can read the values from registers of serial port but at the time
of configuration or writing the values in the register, its not allowing me to
change the reset values. I am not sure about the problem cause.
Thanks,
sachin
____________________________________________________________________________________
Never miss a thing. Make Yahoo your home page.
http://www.yahoo.com/r/hs_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
