Hi Johannes, On 10/24/07, Johannes Berg <[EMAIL PROTECTED]> wrote: > The patch 46249ea60fbb61a72ee6929b831b1f3e6865f024 was obviously done > without testing on a Geyser 1,
My fault, sorry. However Anton's device has product ID of 90x30B which is Geyser 1 as far as I understand... But yes, we should not expect other geysers respond to Geyser 3-specific commands. > and I'm a very annoyed that it was > applied. It causes appletouch to continuously printk: > > drivers/input/mouse/appletouch.c: Could not do mode read request from device > (Geyser 3 mode) > > because the Geyser 1 doesn't respond to that. The patch description also > states: > > > if we see 10 empty packets the touchpad needs to be reset; good > > touchpads should not send empty packets anyway. > > which is *TOTALLY* bogus since Geyser 1 touchpads have no notion of > empty packets, the simply continuously send measurements. One look at > the specification would have confirmed that. > Is there a way to "plug" these Geysers? Waking up the kernel continuously is not nice. -- Dmitry _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
