On Fri, Oct 19, 2007 at 11:32:33AM +0800, Bai Shuwei wrote:
> all,
> hi, when I boot my system, there are no output on the screen.
> I choice the framebuffer and my monitor card is ATI PAGE 128 PCI, qt/e GUI.
> When i compile the kernel, the boot logo and aty 128fb has be compiled into
> kernel patched with videoboot, and x86emu. The video parameters set:
> video=aty128fb:[EMAIL PROTECTED]
> The kenel can recognize the monitor card, and the frame buffer device
> has run.
> The output showed below:
>
> videoboot: Booting PCI video card bus 0, function 0, device 6
> aty128fb: Found Intel x86 BIOS ROM Image
> aty128fb: Rage128 BIOS located
> aty128fb: Rage128 RK PCI [chip rev 0x2] 32M 64-bit SDR SGRAM (2:1)
> fb0: ATY Rage128 frame buffer device on Rage128 RK PCI
>
> My problem is there is no output on the monitor,and cannot see the penguin
> boot logo.
Uh.. most 440 systems use a serial console. It ought in theory to be
possible to use a framebuffer instead, but it wouldn't surprise me if
rather a lot of debugging was necessary.
--
David Gibson | I'll have my music baroque, and my code
david AT gibson.dropbear.id.au | minimalist, thank you. NOT _the_ _other_
| _way_ _around_!
http://www.ozlabs.org/~dgibson
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
