Hi all, I am writing a kernel module which is required to parse the characters received from a device attached to MPC8560 SCC2 (UART slave mode) on serial interface. This SCC is required to be configured for single-buffer, character based operation. Moreover on another SCC (SCC1 UART master mode) the board debug interface(console) is connected.
While trying to figure out CPM UART device driver interface available in file drivers/serial/cpm_uart/cpm_uart_core.c for my kernel module I found that some of the functions are available when CPM_UART_CONSOLE is enabled. My doubt is regarding status of this flag for my hardware setup. Should this flag be enabled or not. If it is required to be enabled for supporting SCC1 then how SCC2 will be handled? As I am a novice in this area , I shall be grateful if you please guide me in understanding this driver code. with regards, Deepak Gaur _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
