I added this to my boot/Makefile near the other mcpu=440 lines. I
believe there may be a fix coming?
$(obj)/treeboot-walnut.o: BOOTCFLAGS += -mcpu=440
$(obj)/4xx.o: BOOTCFLAGS += -mcpu=440
$(obj)/ebony.o: BOOTCFLAGS += -mcpu=440
On 9/24/07, Manil Gaouar <[EMAIL PROTECTED]> wrote:
> Hi there,
>
> I am trying to compile the latest Linux from the git repos: git clone
> git://www.denx.de/git/linux-2.6-denx.git linux-2.6-denx, I checked out
> the code a few weeks ago and was able to build my uImage no problems. I
> did a git pull this morning and I can not compile anymore, here is the
> error message I have:
>
> BOOTCC arch/powerpc/boot/ps3.o
> BOOTCC arch/powerpc/boot/treeboot-bamboo.o
> BOOTCC arch/powerpc/boot/cuboot-sequoia.o
> BOOTCC arch/powerpc/boot/treeboot-walnut.o
> {standard input}: Assembler messages:
> {standard input}:184: Error: Unrecognized opcode: `mfdcr'
> {standard input}:185: Error: Unrecognized opcode: `mfdcr'
> {standard input}:186: Error: Unrecognized opcode: `mfdcr'
> {standard input}:217: Error: Unrecognized opcode: `mtdcr'
> make[1]: *** [arch/powerpc/boot/treeboot-walnut.o] Error 1
> make: *** [uImage] Error 2
>
> here are the commands I am using:
>
> make mrproper
> make ARCH=powerpc CROSS_COMPILE=ppc_6xx- mpc8272_ads_defconfig
> make ARCH=powerpc CROSS_COMPILE=ppc_6xx- uImage
>
> Do you have any ideas, or I should check out the 2.6.22 stable release
> instead and try again???
>
> Thx
> _______________________________________________
> Linuxppc-dev mailing list
> Linuxppc-dev@ozlabs.org
> https://ozlabs.org/mailman/listinfo/linuxppc-dev
>
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
