Currently, xhci_plat is not set up properly when the parent device is an
ACPI node. The conditions that xhci_plat_probe should satisfy are
1. xhci_plat comes from firmware
2. xhci_plat is child of a device from firmware (dwc3-plat)
3. xhci_plat is grandchild of a pci device (dwc3-pci)
Case 2 is covered when the child is an OF node (by checking
sysdev->parent->of_node), however, an ACPI parent will return NULL in
the of_node check and will thus not result in sysdev being set to
sysdev->parent
[ 17.591549] xhci-hcd: probe of xhci-hcd.6.auto failed with error -5
This change adds a check for ACPI to completely allow for condition 2.
This is done by first checking if the parent node is of type ACPI (e.g.,
dwc3-plat) and set sysdev to sysdev->parent if either of the two
following conditions are met:
1: If fwnode is empty (in the case that platform_device_add_properties
was not called on the allocated platform device)
2: fwnode exists but is not of type ACPI (this would happen if
platform_device_add_properties was called on the allocated device.
Instead of type FWNODE_ACPI, you would end up with FWNODE_PDATA)
Cc: sta...@vger.kernel.org #4.12.x
Cc: sta...@vger.kernel.org #4.13.x
Signed-off-by: Adam Wallis <awal...@codeaurora.org>
---
Changes in v2: Incorporate the simplified fwnode check as suggested
by Mathias
drivers/usb/host/xhci-plat.c | 16 ++++++++++------
1 file changed, 10 insertions(+), 6 deletions(-)
diff --git a/drivers/usb/host/xhci-plat.c b/drivers/usb/host/xhci-plat.c
index c04144b..2087407 100644
--- a/drivers/usb/host/xhci-plat.c
+++ b/drivers/usb/host/xhci-plat.c
@@ -186,14 +186,18 @@ static int xhci_plat_probe(struct platform_device *pdev)
* 2. xhci_plat is child of a device from firmware (dwc3-plat)
* 3. xhci_plat is grandchild of a pci device (dwc3-pci)
*/
- sysdev = &pdev->dev;
- if (sysdev->parent && !sysdev->of_node && sysdev->parent->of_node)
- sysdev = sysdev->parent;
+ for (sysdev = &pdev->dev; sysdev; sysdev = sysdev->parent) {
+ if (is_of_node(sysdev->fwnode) ||
+ is_acpi_device_node(sysdev->fwnode))
+ break;
#ifdef CONFIG_PCI
- else if (sysdev->parent && sysdev->parent->parent &&
- sysdev->parent->parent->bus == &pci_bus_type)
- sysdev = sysdev->parent->parent;
+ else if (sysdev->bus == &pci_bus_type)
+ break;
#endif
+ }
+
+ if (!sysdev)
+ sysdev = &pdev->dev;
/* Try to set 64-bit DMA first */
if (WARN_ON(!sysdev->dma_mask))
--
Qualcomm Datacenter Technologies as an affiliate of Qualcomm Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
