On 31.08.2017 20:54, Adam Wallis wrote:
Currently, xhci_plat is not set up properly when the parent device is an
ACPI node. The conditions that xhci_plat_probe should satisfy are
1. xhci_plat comes from firmware
2. xhci_plat is child of a device from firmware (dwc3-plat)
3. xhci_plat is grandchild of a pci device (dwc3-pci)
Case 2 is covered when the child is an OF node (by checking
sysdev->parent->of_node), however, an ACPI parent will return NULL in
the of_node check and will thus not result in sysdev being set to
sysdev->parent
[ 17.591549] xhci-hcd: probe of xhci-hcd.6.auto failed with error -5
This change adds a check for ACPI to completely allow for condition 2.
This is done by first checking if the parent node is of type ACPI (e.g.,
dwc3-plat) and set sysdev to sysdev->parent if either of the two
following conditions are met:
1: If fwnode is empty (in the case that platform_device_add_properties
was not called on the allocated platform device)
2: fwnode exists but is not of type ACPI (this would happen if
platform_device_add_properties was called on the allocated device.
Instead of type FWNODE_ACPI, you would end up with FWNODE_PDATA)
Cc: sta...@vger.kernel.org # 4.12.x
Signed-off-by: Adam Wallis <awal...@codeaurora.org>
---
Thang Q. Nguyen (in CC) proposed a patch for the same issue earlier,
I just replied to his patch with a new proposal (added you to CC)
Basically replace it all with:
- sysdev = &pdev->dev;
- if (sysdev->parent && !sysdev->of_node && sysdev->parent->of_node)
- sysdev = sysdev->parent;
-#ifdef CONFIG_PCI
- else if (sysdev->parent && sysdev->parent->parent &&
- sysdev->parent->parent->bus == &pci_bus_type)
- sysdev = sysdev->parent->parent;
-#endif
+
+ for (sysdev = &pdev->dev; sysdev; sysdev = sysdev->parent) {
+ if (is_of_node(sysdev->fwnode) ||
+ is_acpi_device_node(sysdev->fwnode))
+ break;
+ #ifdef CONFIG_PCI
+ else if (sysdev->bus == &pci_bus_type)
+ break;
+ #endif
+ }
+
+ if (!sysdev)
+ sysdev = &pdev->dev;
-Mathias
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
