A recent change added support for modifying the default line-control
settings, but did not make sure that the modified settings were used as
part of reconfiguration after a device has been reset during resume.
This caused a port that was open before suspend to be unusable until
being closed and reopened.
Fixes: ba781bdf8662 ("USB: serial: ch341: add support for parity, frame
length, stop bits")
Signed-off-by: Johan Hovold <jo...@kernel.org>
---
drivers/usb/serial/ch341.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/usb/serial/ch341.c b/drivers/usb/serial/ch341.c
index 5343d65f3b52..eabdd05a2147 100644
--- a/drivers/usb/serial/ch341.c
+++ b/drivers/usb/serial/ch341.c
@@ -95,6 +95,7 @@ struct ch341_private {
unsigned baud_rate; /* set baud rate */
u8 line_control; /* set line control value RTS/DTR */
u8 line_status; /* active status of modem control inputs */
+ u8 lcr;
};
static void ch341_set_termios(struct tty_struct *tty,
@@ -232,7 +233,7 @@ static int ch341_configure(struct usb_device *dev, struct
ch341_private *priv)
if (r < 0)
goto out;
- r = ch341_init_set_baudrate(dev, priv, 0);
+ r = ch341_init_set_baudrate(dev, priv, priv->lcr);
if (r < 0)
goto out;
@@ -397,6 +398,8 @@ static void ch341_set_termios(struct tty_struct *tty,
if (r < 0 && old_termios) {
priv->baud_rate = tty_termios_baud_rate(old_termios);
tty_termios_copy_hw(&tty->termios, old_termios);
+ } else if (r == 0) {
+ priv->lcr = ctrl;
}
}
--
2.10.2
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
