The ULPI bus is not only for host, but for device mode too, so move
it out from host's Kconfig.
Cc: Heikki Krogerus <heikki.kroge...@linux.intel.com>
Signed-off-by: Peter Chen <peter.c...@nxp.com>
---
drivers/usb/common/Kconfig | 21 +++++++++++++++++++++
drivers/usb/core/Kconfig | 21 ---------------------
2 files changed, 21 insertions(+), 21 deletions(-)
diff --git a/drivers/usb/common/Kconfig b/drivers/usb/common/Kconfig
index 951b1d0..e251aec 100644
--- a/drivers/usb/common/Kconfig
+++ b/drivers/usb/common/Kconfig
@@ -7,3 +7,24 @@ config USB_LED_TRIG
Say Y here if you are working on a system with led-class supported
LEDs and you want to use them as activity indicators for USB host or
gadget.
+
+config USB_ULPI_BUS
+ tristate "USB ULPI PHY interface support"
+ depends on USB_SUPPORT
+ help
+ UTMI+ Low Pin Interface (ULPI) is specification for a commonly used
+ USB 2.0 PHY interface. The ULPI specification defines a standard set
+ of registers that can be used to detect the vendor and product which
+ allows ULPI to be handled as a bus. This module is the driver for that
+ bus.
+
+ The ULPI interfaces (the buses) are registered by the drivers for USB
+ controllers which support ULPI register access and have ULPI PHY
+ attached to them. The ULPI PHY drivers themselves are normal PHY
+ drivers.
+
+ ULPI PHYs provide often functions such as ADP sensing/probing (OTG
+ protocol) and USB charger detection.
+
+ To compile this driver as a module, choose M here: the module will
+ be called ulpi.
diff --git a/drivers/usb/core/Kconfig b/drivers/usb/core/Kconfig
index dd28010..d6e43ce 100644
--- a/drivers/usb/core/Kconfig
+++ b/drivers/usb/core/Kconfig
@@ -82,24 +82,3 @@ config USB_OTG_FSM
help
Implements OTG Finite State Machine as specified in On-The-Go
and Embedded Host Supplement to the USB Revision 2.0 Specification.
-
-config USB_ULPI_BUS
- tristate "USB ULPI PHY interface support"
- depends on USB_SUPPORT
- help
- UTMI+ Low Pin Interface (ULPI) is specification for a commonly used
- USB 2.0 PHY interface. The ULPI specification defines a standard set
- of registers that can be used to detect the vendor and product which
- allows ULPI to be handled as a bus. This module is the driver for that
- bus.
-
- The ULPI interfaces (the buses) are registered by the drivers for USB
- controllers which support ULPI register access and have ULPI PHY
- attached to them. The ULPI PHY drivers themselves are normal PHY
- drivers.
-
- ULPI PHYs provide often functions such as ADP sensing/probing (OTG
- protocol) and USB charger detection.
-
- To compile this driver as a module, choose M here: the module will
- be called ulpi.
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
