From: Hans de Goede <hdego...@redhat.com>

When the board is powering attached usb devices via the otg port
sometimes / on some devices it takes slightly too long for the Vbus
detection code in phy-sun4i-usb.c to signal that Vbus is high after
enabling Vbus and the musb hardware signals a MUSB_INTR_VBUSERROR
interrupt.

This commit sets the otg state to A_WAIT_VRISE upon enabling Vbus
making musb_stage0_irq() ignore the first VBUSERR_RETRY_COUNT
VBUSERROR interrupts, fixing connection issues in these cases.

Signed-off-by: Hans de Goede <hdego...@redhat.com>
[b-...@ti.com: revise subject prefix]
Signed-off-by: Bin Liu <b-...@ti.com>
---
 drivers/usb/musb/sunxi.c | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/usb/musb/sunxi.c b/drivers/usb/musb/sunxi.c
index 2c33d9b..e7d4617 100644
--- a/drivers/usb/musb/sunxi.c
+++ b/drivers/usb/musb/sunxi.c
@@ -112,7 +112,7 @@ static void sunxi_musb_work(struct work_struct *work)
                if (test_bit(SUNXI_MUSB_FL_HOSTMODE, &glue->flags)) {
                        set_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags);
                        musb->xceiv->otg->default_a = 1;
-                       musb->xceiv->otg->state = OTG_STATE_A_IDLE;
+                       musb->xceiv->otg->state = OTG_STATE_A_WAIT_VRISE;
                        MUSB_HST_MODE(musb);
                        devctl |= MUSB_DEVCTL_SESSION;
                } else {
@@ -145,10 +145,12 @@ static void sunxi_musb_set_vbus(struct musb *musb, int 
is_on)
 {
        struct sunxi_glue *glue = dev_get_drvdata(musb->controller->parent);
 
-       if (is_on)
+       if (is_on) {
                set_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags);
-       else
+               musb->xceiv->otg->state = OTG_STATE_A_WAIT_VRISE;
+       } else {
                clear_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags);
+       }
 
        schedule_work(&glue->work);
 }
@@ -325,6 +327,7 @@ static int sunxi_set_mode(struct musb *musb, u8 mode)
                set_bit(SUNXI_MUSB_FL_PHY_ON, &glue->flags);
                /* Stop musb work from turning vbus off again */
                set_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags);
+               musb->xceiv->otg->state = OTG_STATE_A_WAIT_VRISE;
        }
 
        return 0;
-- 
1.9.1

--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to