The status bit was found with USB captures of the Windows driver and
some luck.  Tested on CH340G and CH341A.

v2: unify general status definitions

Signed-off-by: Grigori Goronzy <g...@chown.ath.cx>
---
 drivers/usb/serial/ch341.c | 26 +++++++++++++++++++++-----
 1 file changed, 21 insertions(+), 5 deletions(-)

diff --git a/drivers/usb/serial/ch341.c b/drivers/usb/serial/ch341.c
index 78adce7..12a430c 100644
--- a/drivers/usb/serial/ch341.c
+++ b/drivers/usb/serial/ch341.c
@@ -39,9 +39,6 @@
 /* third irq byte base 0x94 + below */
 /* fourth irq byte normally 0xee */
 
-/* second interrupt byte */
-#define CH341_MULT_STAT 0x04 /* multiple status since last interrupt event */
-
 /* status returned in third interrupt answer byte, inverted in data
    from irq */
 #define CH341_BIT_CTS 0x01
@@ -81,6 +78,10 @@
 #define CH341_LCR_CS6          0x01
 #define CH341_LCR_CS5          0x00
 
+/* General status from register 0x07 and second interrupt byte */
+#define CH341_STATUS_TXBUSY    0x01
+#define CH341_STATUS_MULTI     0x04
+
 static const struct usb_device_id id_table[] = {
        { USB_DEVICE(0x4348, 0x5523) },
        { USB_DEVICE(0x1a86, 0x7523) },
@@ -94,6 +95,7 @@ struct ch341_private {
        unsigned baud_rate; /* set baud rate */
        u8 line_control; /* set line control value RTS/DTR */
        u8 line_status; /* active status of modem control inputs */
+       u8 uart_status; /* generic UART status bits */
 };
 
 static void ch341_set_termios(struct tty_struct *tty,
@@ -184,7 +186,8 @@ static int ch341_get_status(struct usb_device *dev, struct 
ch341_private *priv)
        if (r == 2) {
                r = 0;
                spin_lock_irqsave(&priv->lock, flags);
-               priv->line_status = (~(*buffer)) & CH341_BITS_MODEM_STAT;
+               priv->line_status = (~buffer[0]) & CH341_BITS_MODEM_STAT;
+               priv->uart_status = buffer[1];
                spin_unlock_irqrestore(&priv->lock, flags);
        } else {
                r = -EPROTO;
@@ -195,6 +198,18 @@ out:
        return r;
 }
 
+static bool ch341_tx_empty(struct usb_serial_port *port)
+{
+       int r;
+       struct ch341_private *priv = usb_get_serial_port_data(port);
+
+       r = ch341_get_status(port->serial->dev, priv);
+       if (r < 0)
+               return true;
+
+       return !(priv->uart_status & CH341_STATUS_TXBUSY);
+}
+
 /* -------------------------------------------------------------------------- 
*/
 
 static int ch341_configure(struct usb_device *dev, struct ch341_private *priv)
@@ -493,7 +508,7 @@ static void ch341_update_line_status(struct usb_serial_port 
*port,
        priv->line_status = status;
        spin_unlock_irqrestore(&priv->lock, flags);
 
-       if (data[1] & CH341_MULT_STAT)
+       if (data[1] & CH341_STATUS_MULTI)
                dev_dbg(&port->dev, "Multiple status change\n");
 
        if (!delta)
@@ -599,6 +614,7 @@ static struct usb_serial_driver ch341_device = {
        .carrier_raised    = ch341_carrier_raised,
        .close             = ch341_close,
        .set_termios       = ch341_set_termios,
+       .tx_empty          = ch341_tx_empty,
        .break_ctl         = ch341_break_ctl,
        .tiocmget          = ch341_tiocmget,
        .tiocmset          = ch341_tiocmset,
-- 
1.9.1

--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to