On Thu, Mar 10, 2016 at 3:59 PM, Oliver Neukum <[email protected]> wrote:
> Adding the descriptors of chapter 9.2 of the Power Delivery spec.
>
> Signed-off-by: Oliver Neukum <[email protected]>
> ---
> include/uapi/linux/usb/ch9.h | 98
> ++++++++++++++++++++++++++++++++++++++++++++
> 1 file changed, 98 insertions(+)
>
> diff --git a/include/uapi/linux/usb/ch9.h b/include/uapi/linux/usb/ch9.h
> index 06d6c62..1046c55 100644
> --- a/include/uapi/linux/usb/ch9.h
> +++ b/include/uapi/linux/usb/ch9.h
> @@ -914,6 +914,104 @@ struct usb_ssp_cap_descriptor {
> } __attribute__((packed));
>
> /*
> + * USB Power Delivery Capability Descriptor:
> + * Defines capabilities for PD
> + */
> +/* Defines the various PD Capabilities of this device */
> +#define USB_PD_POWER_DELIVERY_CAPABILITY 0x06
> +/* Provides information on each battery supported by the device */
> +#define USB_PD_BATTERY_INFO_CAPABILITY 0x07
> +/* The Consumer characteristics of a Port on the device */
> +#define USB_PD_PD_CONSUMER_PORT_CAPABILITY 0x08
> +/* The provider characteristics of a Port on the device */
> +#define USB_PD_PD_PROVIDER_PORT_CAPABILITY 0x09
> +
> +struct usb_pd_cap_descriptor {
> + __u8 bLength;
> + __u8 bDescriptorType;
> + __u8 bDevCapabilityType; /* set to USB_PD_POWER_DELIVERY_CAPABILITY
> */
> + __u8 bReserved;
> + __le32 bmAttributes;
> +#define USB_PD_CAP_BATTERY_CHARGING (1 << 1) /* supports Battery Charging
> specification */
> +#define USB_PD_CAP_USB_PD (1 << 2) /* supports USB Power
> Delivery specification */
> +#define USB_PD_CAP_PROVIDER (1 << 3) /* can provide power */
> +#define USB_PD_CAP_CONSUMER (1 << 4) /* can consume power */
> +#define USB_PD_CAP_CHARGING_POLICY (1 << 5) /* supports CHARGING_POLICY
> feature */
> +#define USB_PD_CAP_TYPE_C_CURRENT (1 << 6) /* supports power
> capabilities defined in the USB Type-C Specification */
> +
> +#define USB_PD_CAP_PWR_AC (1 << 8)
> +#define USB_PD_CAP_PWR_BAT (1 << 9)
> +#define USB_PD_CAP_PWR_USE_V_BUS (1 << 14)
Thank you for fixing uSB_xxx here
> +
> + __le16 bmProviderPorts; /* Bit zero refers to the UFP of the device */
> + __le16 bmConsumerPorts;
> + __le16 bcdBCVersion;
> + __le16 bcdPDVersion;
> + __le16 bcdUSBTypeCVersion;
> +} __attribute__((packed));
> +
> +struct usb_pd_cap_battery_info_descriptor {
> + __u8 bLength;
> + __u8 bDescriptorType;
> + __u8 bDevCapabilityType;
> + /* Index of string descriptor shall contain the user friendly name
> for this battery */
> + __u8 iBattery;
> + /* Index of string descriptor shall contain the Serial Number String
> for this battery */
> + __u8 iSerial;
> + __u8 iManufacturer;
> + __u8 bBatteryId; /* uniquely identifies this battery in status
> Messages */
> + __u8 bReserved;
> + /*
> + * Shall contain the Battery Charge value above which this
> + * battery is considered to be fully charged but not necessarily
> + * “topped off.”
> + */
> + __le32 dwChargedThreshold; /* in mWh */
> + /*
> + * Shall contain the minimum charge level of this battery such
> + * that above this threshold, a device can be assured of being
> + * able to power up successfully (see Battery Charging 1.2).
> + */
> + __le32 dwWeakThreshold; /* in mWh */
> + __le32 dwBatteryDesignCapacity; /* in mWh */
> + __le32 dwBatteryLastFullchargeCapacity; /* in mWh */
> +} __attribute__((packed));
> +
> +struct usb_pd_cap_consumer_port_descriptor {
> + __u8 bLength;
> + __u8 bDescriptorType;
> + __u8 bDevCapabilityType;
> + __u8 bReserved;
> + __u8 bmCapabilities;
> +/* port will oerate under: */
> +#define uSB_PD_CAP_CONSUMER_BC (1 << 0) /* BC */
> +#define uSB_PD_CAP_CONSUMER_PD (1 << 1) /* PD */
> +#define uSB_PD_CAP_CONSUMER_TYPE_C (1 << 2) /* USB Type-C Current */
However, this typo still exists here ^
> + __le16 wMinVoltage; /* in 50mV units */
> + __le16 wMaxVoltage; /* in 50mV units */
> + __u16 wReserved;
> + __le32 dwMaxOperatingPower; /* in 10 mW - operating at steady state */
> + __le32 dwMaxPeakPower; /* in 10mW units - operating at peak power */
> + __le32 dwMaxPeakPowerTime; /* in 100ms units - duration of peak */
> +#define uSB_PD_CAP_CONSUMER_UNKNOWN_PEAK_POWER_TIME 0xffff
and here ^
> +} __attribute__((packed));
> +
> +struct usb_pd_cap_provider_port_descriptor {
> + __u8 bLength;
> + __u8 bDescriptorType;
> + __u8 bDevCapabilityType;
> + __u8 bReserved1;
> + __u8 bmCapabilities;
> +/* port will oerate under: */
> +#define uSB_PD_CAP_PROVIDER_BC (1 << 0) /* BC */
> +#define uSB_PD_CAP_PROVIDER_PD (1 << 1) /* PD */
> +#define uSB_PD_CAP_PROVIDER_TYPE_C (1 << 2) /* USB Type-C Current */
..and here ^
Could you please fix it in all places?
Thanks,
Ruslan
> + __u8 bNumOfPDObjects;
> + __u8 bReserved2;
> + __le32 wPowerDataObject[];
> +} __attribute__((packed));
> +
> +/*
> * Precision time measurement capability descriptor: advertised by devices
> and
> * hubs that support PTM
> */
> --
> 2.1.4
>
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html