From: Evgeny Boger <[email protected]> Date: Sun, 11 May 2014 17:34:14 +0400
> There might be 11 GPIOs in total. Last three GPIOs (offsets 8-11, 0-based) > are shared > with FDX, LNKA, SPD LEDs respectively. The LEDs are driven by chip by default > at startup time. Once the corresponding GPIO is requested, the chip LED drive > logic is disabled. > > Based on commented out code presumably from SMSC original driver. > https://github.com/olerem/barebox/blob/master/drivers/net/usb/smsc95xx.c > > Signed-off-by: Evgeny Boger <[email protected]> Won't you need to add some GPIOLIB logic to the Kconfig entry for this driver? Also: > +} > + > + > +static int smsc95xx_gpio_request(struct gpio_chip *gpio, unsigned offset) One empty line is sufficient between functions, please delete on of these two. > +{ > + int ret = -1; > + u32 val, reg; > + int type_shift; > + > + struct smsc95xx_priv *pdata = > + container_of(gpio, struct smsc95xx_priv, gpio); Please do not put empty lines in the middle of local function variable declarations. > + int ret = -1; > + u32 val, reg; > + int type_shift; > + > + struct smsc95xx_priv *pdata = > + container_of(gpio, struct smsc95xx_priv, gpio); Likewise. > + int ret = -1; > + u32 val, reg; > + > + struct smsc95xx_priv *pdata = > + container_of(gpio, struct smsc95xx_priv, gpio); > + reg = smsc95xx_gpio_get_register(offset); Likewise. > + int ret = -1; > + u32 val, reg; > + > + struct smsc95xx_priv *pdata = > + container_of(gpio, struct smsc95xx_priv, gpio); Likewise. > + int ret = -1; > + u32 val, reg; > + > + struct smsc95xx_priv *pdata = > + container_of(gpio, struct smsc95xx_priv, gpio); > + reg = smsc95xx_gpio_get_register(offset); Likewise and do put an empty line after the variable declarations and before the first real C statement. > @@ -1153,17 +1404,32 @@ static int smsc95xx_bind(struct usbnet *dev, struct > usb_interface *intf) > dev->net->flags |= IFF_MULTICAST; > dev->net->hard_header_len += SMSC95XX_TX_OVERHEAD_CSUM; > dev->hard_mtu = dev->net->mtu + dev->net->hard_header_len; > + > + ret = smsc95xx_register_gpio(dev); > + if (ret < 0) > + return ret; > + > return 0; > } I think you will leak dev->data[0] if you exit here with an error and without explicitly freeing dev->data[0] like the unbind method does. -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
