On Monday, October 14, 2013 3:01 PM, Ryan Mallon wrote:
> On 15/10/13 08:35, H Hartley Sweeten wrote:
>> Convert ep93xx to use the OHCI platform driver and remove the
>> ohci-ep93xx bus glue driver.
>>
>> Signed-off-by: H Hartley Sweeten <hswee...@visionengravers.com>
>> Cc: Alan Stern <st...@rowland.harvard.edu>
>> Cc: Greg Kroah-Hartman <gre...@linuxfoundation.org>
>> Cc: Ryan Mallon <rmal...@gmail.com>
>> ---
>
>> diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
>> index b3f20d7..2c8f2db 100644
>> --- a/drivers/usb/host/Kconfig
>> +++ b/drivers/usb/host/Kconfig
>> @@ -472,7 +472,7 @@ config USB_CNS3XXX_OHCI
>>
>> config USB_OHCI_HCD_PLATFORM
>> tristate "Generic OHCI driver for a platform device"
>> - default n
>> + default y if ARCH_EP93XX
>
> Shouldn't we select USB_OHCI_HCD_PLATFORM, e.g. something like:
>
> config ARCH_EP93XX_USB
> tristate "USB OHCI support"
> default y
> select USB_OHCI_HCD_PLATFORM
>
> In arch/arm/mach-ep93xx/Kconfig rather than polluting
> drivers/usb/host/Kconfig with arch specific stuff?
I wasn't sure where the best place to enable
USB_OHCI_HCD_PLATFORM would be.
Currently USB support on the EP93xx only needs USB_OHCI_HCD
enabled, which is already enabled in the ep93xx_defconfig. I'm not
sure if adding the config option above would create a problem where
the user would need to enable USB_OHCI_HCD in drivers/usb then
have to go back to the arch stuff to enable ARCH_EP93XX_USB.
With the default y above they just have to enable USB_OHCI_HCD
like they currently do.
I'm hoping Alan can provide some feedback.
Regards,
Hartley
N�����r��y����b�X��ǧv�^�){.n�+����{������^n�r���z���h�����&�� �G���h�(�階�ݢj"���m������z�ޖ���f���h���~�m�
