Currently hw_phymode_configure() is located inside hw_device_reset(), which is
only called by chipidea udc driver.
When operating in host mode, we also need to call hw_phymode_configure() in
order to properly configure the PHY mode, so move this function into probe.
After this change, USB Host1 port on mx53qsb board is functional.
Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
---
drivers/usb/chipidea/core.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/usb/chipidea/core.c b/drivers/usb/chipidea/core.c
index a5df24c..a5b3774 100644
--- a/drivers/usb/chipidea/core.c
+++ b/drivers/usb/chipidea/core.c
@@ -264,8 +264,6 @@ int hw_device_reset(struct ci_hdrc *ci, u32 mode)
while (hw_read(ci, OP_USBCMD, USBCMD_RST))
udelay(10); /* not RTOS friendly */
- hw_phymode_configure(ci);
-
if (ci->platdata->notify_event)
ci->platdata->notify_event(ci,
CI_HDRC_CONTROLLER_RESET_EVENT);
@@ -457,6 +455,8 @@ static int ci_hdrc_probe(struct platform_device *pdev)
if (!ci->platdata->phy_mode)
ci->platdata->phy_mode = of_usb_get_phy_mode(dev->of_node);
+ hw_phymode_configure(ci);
+
if (!ci->platdata->dr_mode)
ci->platdata->dr_mode = of_usb_get_dr_mode(dev->of_node);
--
1.8.1.2
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
