On Tue, Sep 17, 2019 at 04:40:47PM +0530, Chandana Kishori Chiluveru wrote: > Add documentation for the interconnects and interconnect-names > properties for USB as detailed by bindings/interconnect/interconnect.txt. > > Signed-off-by: Chandana Kishori Chiluveru <cchil...@codeaurora.org> > --- > Documentation/devicetree/bindings/usb/qcom,dwc3.txt | 13 +++++++++++++ > 1 file changed, 13 insertions(+) > > diff --git a/Documentation/devicetree/bindings/usb/qcom,dwc3.txt > b/Documentation/devicetree/bindings/usb/qcom,dwc3.txt > index cb695aa..428565b 100644 > --- a/Documentation/devicetree/bindings/usb/qcom,dwc3.txt > +++ b/Documentation/devicetree/bindings/usb/qcom,dwc3.txt > @@ -33,6 +33,16 @@ Optional clocks: > > Optional properties: > - resets: Phandle to reset control that resets core and wrapper. > +- interconnects: Pairs of phandles and interconnect provider specifiers > + to denote the edge source and destination ports of > + the interconnect path. Please refer to > + Documentation/devicetree/bindings/interconnect/ > + for more details. > +- interconnect-names: List of interconnect path name strings sorted > in the same > + order as the interconnects property. Consumers drivers > will use
nit: Consumer no need to re-spin the series just for this. > + interconnect-names to match interconnect paths with > interconnect > + specifiers. Please refer to > Documentation/devicetree/bindings/ > + interconnect/ for more details. > - interrupts: specifies interrupts from controller wrapper > used > to wakeup from low power/susepnd state. Must contain > one or more entry for interrupt-names property > @@ -74,6 +84,9 @@ Example device nodes: > #size-cells = <1>; > ranges; > > + interconnects = <&qnoc MASTER_USB3_0 &qnoc SLAVE_EBI1>, > + <&qnoc MASTER_APPSS_PROC &qnoc > SLAVE_USB3_0>; > + interconnect-names = "usb-ddr", "apps-usb"; > interrupts = <0 131 0>, <0 486 0>, <0 488 0>, <0 489 0>; > interrupt-names = "hs_phy_irq", "ss_phy_irq", > "dm_hs_phy_irq", "dp_hs_phy_irq"; Reviewed-by: Matthias Kaehlcke <m...@chromium.org>
