Hi, I am having some problems with Kingston Datatravler USB flash drive. The key works fine when there is no mouse or other HID device is connected to the system however once you plug the mouse in and reinsert the USB key I get the following. This is a old board and is using the UHCI host controller. I have tried 3 of these keys so far and none of them work.
usb 1-2: new full speed USB device using uhci_hcd and address 8 usb 1-2: configuration #1 chosen from 1 choice scsi1 : SCSI emulation for USB Mass Storage devices usb-storage: device found at 8 usb-storage: waiting for device to settle before scanning Vendor: Kingston Model: DataTraveler 2.0 Rev: 1.00 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sda: 3987456 512-byte hdwr sectors (2042 MB) sda: Write Protect is off sda: Mode Sense: 23 00 00 00 sda: assuming drive cache: write through SCSI device sda: 3987456 512-byte hdwr sectors (2042 MB) sda: Write Protect is off sda: Mode Sense: 23 00 00 00 sda: assuming drive cache: write through sda:<6>usb 1-2: reset full speed USB device using uhci_hcd and address 8 usb 1-2: device descriptor read/64, error -84 usb 1-2: device descriptor read/64, error -84 usb 1-2: reset full speed USB device using uhci_hcd and address 8 usb 1-2: device descriptor read/64, error -32 usb 1-2: device descriptor read/64, error -32 usb 1-2: reset full speed USB device using uhci_hcd and address 8 usb 1-2: device not accepting address 8, error -32 usb 1-2: reset full speed USB device using uhci_hcd and address 8 usb 1-2: device not accepting address 8, error -32 usb 1-2: USB disconnect, address 8 sd 1:0:0:0: SCSI error: return code = 0x00010000 end_request: I/O error, dev sda, sector 0 Buffer I/O error on device sda, logical block 0 sd 1:0:0:0: SCSI error: return code = 0x00010000 end_request: I/O error, dev sda, sector 0 Buffer I/O error on device sda, logical block 0 unable to read partition table sd 1:0:0:0: Attached scsi removable disk sda sd 1:0:0:0: Attached scsi generic sg0 type 0 usb-storage: device scan complete usb 1-2: new full speed USB device using uhci_hcd and address 9 usb 1-2: device descriptor read/64, error -32 usb 1-2: device descriptor read/64, error -32 usb 1-2: new full speed USB device using uhci_hcd and address 10 usb 1-2: device descriptor read/64, error -32 usb 1-2: device descriptor read/64, error -32 usb 1-2: new full speed USB device using uhci_hcd and address 11 usb 1-2: device not accepting address 11, error -32 usb 1-2: new full speed USB device using uhci_hcd and address 12 usb 1-2: device not accepting address 12, error -32 Regards, Brian J. - To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
