megaraid_sas takes 1+ seconds to load while waiting for firmware:
[2.822603] megaraid_sas 0000:03:00.0: Waiting for FW to come to ready state
[3.871003] megaraid_sas 0000:03:00.0: FW now in Ready state
This is due to the following loop in megasas_transition_to_ready(), which
waits a minimum of 1 second, even though the FW becomes ready in tens of
millisecs:
/*
* The cur_state should not last for more than max_wait secs
*/
for (i = 0; i < max_wait; i++) {
...
msleep(1000);
...
dev_info(&instance->pdev->dev, "FW now in Ready state\n");
This is a regression, caused by a change of the msleep granularity from 1 to
1000 due to concern about waiting too long on systems with coarse jiffies.
To fix, increase iterations and use msleep(20), which results in:
[2.670627] megaraid_sas 0000:03:00.0: Waiting for FW to come to ready state
[2.739386] megaraid_sas 0000:03:00.0: FW now in Ready state
Fixes: fb2f3e96d80f ("scsi: megaraid_sas: Fix msleep granularity")
Signed-off-by: Steve Sistare <steven.sist...@oracle.com>
---
drivers/scsi/megaraid/megaraid_sas_base.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/scsi/megaraid/megaraid_sas_base.c
b/drivers/scsi/megaraid/megaraid_sas_base.c
index a30c1b3..a707af5 100644
--- a/drivers/scsi/megaraid/megaraid_sas_base.c
+++ b/drivers/scsi/megaraid/megaraid_sas_base.c
@@ -3932,12 +3932,12 @@ static irqreturn_t megasas_isr(int irq, void *devp)
/*
* The cur_state should not last for more than max_wait secs
*/
- for (i = 0; i < max_wait; i++) {
+ for (i = 0; i < max_wait * 50; i++) {
curr_abs_state = instance->instancet->
read_fw_status_reg(instance);
if (abs_state == curr_abs_state) {
- msleep(1000);
+ msleep(20);
} else
break;
}
--
1.8.3.1
