The queuecommand routine has a local dev pointer used for the
dev_* prints. The two prints that currently exist are tucked
under a debug define and thus can be left out. Use the actual
location instead of a local to avoid this warning.
This patch is intended to be applied after the "CXL Flash Error
Recovery and Superpipe" series.
Signed-off-by: Matthew R. Ochs <mro...@linux.vnet.ibm.com>
Signed-off-by: Manoj N. Kumar <ma...@linux.vnet.ibm.com>
Reported-by: kbuild test robot <fengguang...@intel.com>
---
drivers/scsi/cxlflash/main.c | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)
diff --git a/drivers/scsi/cxlflash/main.c b/drivers/scsi/cxlflash/main.c
index 458ed83..3ccb546 100644
--- a/drivers/scsi/cxlflash/main.c
+++ b/drivers/scsi/cxlflash/main.c
@@ -354,7 +354,6 @@ static int cxlflash_queuecommand(struct Scsi_Host *host,
struct scsi_cmnd *scp)
struct cxlflash_cfg *cfg = (struct cxlflash_cfg *)host->hostdata;
struct afu *afu = cfg->afu;
struct pci_dev *pdev = cfg->dev;
- struct device *dev = &cfg->dev->dev;
struct afu_cmd *cmd;
u32 port_sel = scp->device->channel + 1;
int nseg, i, ncount;
@@ -384,11 +383,13 @@ static int cxlflash_queuecommand(struct Scsi_Host *host,
struct scsi_cmnd *scp)
switch (cfg->state) {
case STATE_LIMBO:
- dev_dbg_ratelimited(dev, "%s: device in limbo!\n", __func__);
+ dev_dbg_ratelimited(&cfg->dev->dev, "%s: device in limbo!\n",
+ __func__);
rc = SCSI_MLQUEUE_HOST_BUSY;
goto out;
case STATE_FAILTERM:
- dev_dbg_ratelimited(dev, "%s: device has failed!\n", __func__);
+ dev_dbg_ratelimited(&cfg->dev->dev, "%s: device has failed!\n",
+ __func__);
scp->result = (DID_NO_CONNECT << 16);
scp->scsi_done(scp);
rc = 0;
--
2.1.0
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
