Hi, I got a new USB3->SATA adapter that throws the following errors when trying to mount the ext4 file system on the attached disk.
Jun 26 20:47:11 wiggum kernel: [156016.840175] usb 4-2: new SuperSpeed USB device number 8 using xhci_hcd Jun 26 20:47:11 wiggum kernel: [156016.856962] usb 4-2: New USB device found, idVendor=152d, idProduct=0567 Jun 26 20:47:11 wiggum kernel: [156016.856969] usb 4-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 Jun 26 20:47:11 wiggum kernel: [156016.856972] usb 4-2: Product: USB to ATA/ATAPI Bridge Jun 26 20:47:11 wiggum kernel: [156016.856975] usb 4-2: Manufacturer: JMicron Jun 26 20:47:11 wiggum kernel: [156016.856977] usb 4-2: SerialNumber: xxx Jun 26 20:47:11 wiggum kernel: [156016.858030] usb-storage 4-2:1.0: USB Mass Storage device detected Jun 26 20:47:11 wiggum kernel: [156016.858141] scsi22 : usb-storage 4-2:1.0 Jun 26 20:47:12 wiggum kernel: [156017.857096] scsi 22:0:0:0: Direct-Access JMicron Generic 0114 PQ: 0 ANSI: 6 Jun 26 20:47:12 wiggum kernel: [156017.857427] sd 22:0:0:0: Attached scsi generic sg1 type 0 Jun 26 20:47:12 wiggum kernel: [156017.860670] sd 22:0:0:0: [sdb] Spinning up disk... Jun 26 20:47:14 wiggum kernel: [156018.865281] ..ready Jun 26 20:47:14 wiggum kernel: [156019.870310] sd 22:0:0:0: [sdb] 976773168 512-byte logical blocks: (500 GB/465 GiB) Jun 26 20:47:14 wiggum kernel: [156019.870653] sd 22:0:0:0: [sdb] Write Protect is off Jun 26 20:47:14 wiggum kernel: [156019.870659] sd 22:0:0:0: [sdb] Mode Sense: 47 00 10 08 Jun 26 20:47:14 wiggum kernel: [156019.870956] sd 22:0:0:0: [sdb] Write cache: enabled, read cache: enabled, supports DPO and FUA Jun 26 20:47:14 wiggum kernel: [156019.924517] sdb: sdb1 Jun 26 20:47:14 wiggum kernel: [156019.928649] sd 22:0:0:0: [sdb] Attached SCSI disk Jun 26 20:47:27 wiggum kernel: [156032.936896] JBD2: Clearing recovery information on journal Jun 26 20:47:27 wiggum kernel: [156032.938218] sd 22:0:0:0: [sdb] Invalid command failure Jun 26 20:47:27 wiggum kernel: [156032.938222] sd 22:0:0:0: [sdb] Jun 26 20:47:27 wiggum kernel: [156032.938225] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE Jun 26 20:47:27 wiggum kernel: [156032.938228] sd 22:0:0:0: [sdb] Jun 26 20:47:27 wiggum kernel: [156032.938230] Sense Key : Illegal Request [current] Jun 26 20:47:27 wiggum kernel: [156032.938234] sd 22:0:0:0: [sdb] Jun 26 20:47:27 wiggum kernel: [156032.938237] Add. Sense: Invalid field in cdb Jun 26 20:47:27 wiggum kernel: [156032.938239] sd 22:0:0:0: [sdb] CDB: Jun 26 20:47:27 wiggum kernel: [156032.938241] Write(10): 2a 08 1d 04 00 3f 00 00 08 00 Jun 26 20:47:27 wiggum kernel: [156032.938247] end_request: critical target error, dev sdb, sector 486801471 Jun 26 20:47:27 wiggum kernel: [156032.938249] Buffer I/O error on device sdb1, logical block 60850176 Jun 26 20:47:27 wiggum kernel: [156032.938251] lost page write due to I/O error on sdb1 Jun 26 20:47:27 wiggum kernel: [156032.938260] JBD2: Error -5 detected when updating journal superblock for sdb1-8. Does somebody have a hint to debug this? -- Michael.
signature.asc
Description: PGP signature
