On 08/16/2013 10:26 AM, Evgeny wrote: > Hello. > > I've been testing vanilla 3.4.45 (config attached), 3.4.56 kernels on > centos 5.9 with Adaptec AIC-9410W SAS controller:
There's some fix in libsas about error handle , As I remember most of patch finally merged in 3.7, could you try newer kernel? KR Jack > > ------------ > 09:02.0 RAID bus controller: Adaptec AIC-9410W SAS (Razor ASIC RAID) > (rev 09) > Subsystem: Super Micro Computer Inc Device 9280 > Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr+ > Stepping- SERR+ FastB2B- DisINTx- > Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- > <TAbort- <MAbort- >SERR- <PERR- INTx- > Latency: 64 (32000ns min, 26750ns max), Cache Line Size: 32 bytes > Interrupt: pin A routed to IRQ 18 > Region 0: Memory at d8300000 (64-bit, non-prefetchable) [size=256K] > Region 2: Memory at d8000000 (64-bit, prefetchable) [size=128K] > Region 4: I/O ports at 3000 [size=256] > [virtual] Expansion ROM at d8080000 [disabled] [size=512K] > Capabilities: [40] PCI-X non-bridge device > Command: DPERE- ERO- RBC=4096 OST=8 > Status: Dev=09:02.0 64bit+ 133MHz+ SCD- USC- DC=simple > DMMRBC=4096 DMOST=8 DMCRS=128 RSCEM- 266MHz- 533MHz- > Capabilities: [58] Power Management version 2 > Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA > PME(D0-,D1-,D2-,D3hot-,D3cold-) > Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- > Capabilities: [e0] MSI: Enable- Count=1/4 Maskable- 64bit+ > Address: 0000000000000000 Data: 0000 > Kernel driver in use: aic94xx > Kernel modules: aic94xx > ---------- > > Under a heavy load made by bonnie: > > ---------- > bonnie++ -d /tmp/test -x 10000 -s 24g -u root > ---------- > > after 8-14 hours system gets kernel panic (log attached). > > Could anyone help with it? > > > Thanks! > Evgeny -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
