When SCSI command is received with task attribute not set, set it to SIMPLE.
Previously it is set to untagged. This causes the firmware to fail the commands.
Signed-off-by: Sreekanth Reddy <sreekanth.re...@lsi.com>
Cc: sta...@vger.kernel.org
---
diff --git a/drivers/scsi/mpt2sas/mpt2sas_scsih.c
b/drivers/scsi/mpt2sas/mpt2sas_scsih.c
index 014caef..3b150b8 100644
--- a/drivers/scsi/mpt2sas/mpt2sas_scsih.c
+++ b/drivers/scsi/mpt2sas/mpt2sas_scsih.c
@@ -3998,11 +3998,7 @@ _scsih_qcmd_lck(struct scsi_cmnd *scmd, void
(*done)(struct scsi_cmnd *))
else
mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ;
} else
-/* MPI Revision I (UNIT = 0xA) - removed MPI2_SCSIIO_CONTROL_UNTAGGED */
-/* mpi_control |= MPI2_SCSIIO_CONTROL_UNTAGGED;
- */
- mpi_control |= (0x500);
-
+ mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ;
} else
mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ;
/* Make sure Device is not raid volume.
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
