The Coverity checker noted that we'll anyway Oops later when we ran into
this condition - and the error check didn't prevent that.
Considering that the error condition shouldn't be possible, and we are
not able to handle it easily, this patch simply removes the pointless
error check.
Signed-off-by: Adrian Bunk <[EMAIL PROTECTED]>
---
This patch has been sent on:
- 23 Jul 2007
drivers/scsi/nsp32.c | 4 ----
1 file changed, 4 deletions(-)
--- linux-2.6.22-rc6-mm1/drivers/scsi/nsp32.c.old 2007-07-23
19:38:58.000000000 +0200
+++ linux-2.6.22-rc6-mm1/drivers/scsi/nsp32.c 2007-07-23 20:17:14.000000000
+0200
@@ -1888,44 +1888,40 @@ static void nsp32_msgout_occur(struct sc
data->msgout_len = 0;
nsp32_dbg(NSP32_DEBUG_MSGOUTOCCUR, "exit");
}
/*
* Restart AutoSCSI
*
* Note: Restarting AutoSCSI needs set:
* SYNC_REG, ACK_WIDTH, SGT_ADR, TRANSFER_CONTROL
*/
static void nsp32_restart_autoscsi(struct scsi_cmnd *SCpnt, unsigned short
command)
{
nsp32_hw_data *data = (nsp32_hw_data *)SCpnt->device->host->hostdata;
unsigned int base = data->BaseAddress;
unsigned short transfer = 0;
nsp32_dbg(NSP32_DEBUG_RESTART, "enter");
- if (data->cur_target == NULL || data->cur_lunt == NULL) {
- nsp32_msg(KERN_ERR, "Target or Lun is invalid");
- }
-
/*
* set SYNC_REG
* Don't set BM_START_ADR before setting this register.
*/
nsp32_write1(base, SYNC_REG, data->cur_target->syncreg);
/*
* set ACKWIDTH
*/
nsp32_write1(base, ACK_WIDTH, data->cur_target->ackwidth);
/*
* set SREQ hazard killer sampling rate
*/
nsp32_write1(base, SREQ_SMPL_RATE, data->cur_target->sample_reg);
/*
* set SGT ADDR (physical address)
*/
nsp32_write4(base, SGT_ADR, data->cur_lunt->sglun_paddr);
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
