Correct LED scheme definition.
Original implementation used an overloaded bit in the EFI
parameters. The correct bit is BIT_4 of the special_options
section of NVRAM.
Signed-off-by: Andrew Vasquez <[EMAIL PROTECTED]>
---
drivers/scsi/qla2xxx/qla_def.h | 4 ++--
drivers/scsi/qla2xxx/qla_init.c | 2 +-
2 files changed, 3 insertions(+), 3 deletions(-)
54e2e1934181c71de6b758123c74f397b8e8fb00
diff --git a/drivers/scsi/qla2xxx/qla_def.h b/drivers/scsi/qla2xxx/qla_def.h
--- a/drivers/scsi/qla2xxx/qla_def.h
+++ b/drivers/scsi/qla2xxx/qla_def.h
@@ -914,7 +914,7 @@ typedef struct {
* MSB BIT 1 =
* MSB BIT 2 =
* MSB BIT 3 =
- * MSB BIT 4 =
+ * MSB BIT 4 = LED mode
* MSB BIT 5 = enable 50 ohm termination
* MSB BIT 6 = Data Rate (2300 only)
* MSB BIT 7 = Data Rate (2300 only)
@@ -1036,7 +1036,7 @@ typedef struct {
* MSB BIT 1 =
* MSB BIT 2 =
* MSB BIT 3 =
- * MSB BIT 4 =
+ * MSB BIT 4 = LED mode
* MSB BIT 5 = enable 50 ohm termination
* MSB BIT 6 = Data Rate (2300 only)
* MSB BIT 7 = Data Rate (2300 only)
diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -1568,7 +1568,7 @@ qla2x00_nvram_config(scsi_qla_host_t *ha
ha->flags.enable_lip_reset = ((nv->host_p[1] & BIT_1) ? 1 : 0);
ha->flags.enable_lip_full_login = ((nv->host_p[1] & BIT_2) ? 1 : 0);
ha->flags.enable_target_reset = ((nv->host_p[1] & BIT_3) ? 1 : 0);
- ha->flags.enable_led_scheme = ((nv->efi_parameters & BIT_3) ? 1 : 0);
+ ha->flags.enable_led_scheme = (nv->special_options[1] & BIT_4) ? 1 : 0;
ha->operating_mode =
(icb->add_firmware_options[0] & (BIT_6 | BIT_5 | BIT_4)) >> 4;
--
Andrew Vasquez
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
