Hi,
I have a RH7 system which I have just compiled kernel-2.4.2 for. The box has
an Asus CUV4X-D motherboard, and an Adaptec 29160 PCI SCSI controller. I'm
using the AIC7xxx driver.
Everything works, except the hard drive is a Quantum Atlas 10K2, 160MB/sec,
but is only detected as 80MB/sec, as follows:
# dmesg
...
SCSI subsystem driver Revision: 1.00
(scsi0) <Adaptec AIC-7892 Ultra 160/m SCSI host adapter> found at PCI 0/11/0
(scsi0) Wide Channel, SCSI ID=7, 32/255 SCBs
(scsi0) Downloading sequencer code... 392 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.2.1/5.2.0
<Adaptec AIC-7892 Ultra 160/m SCSI host adapter>
(scsi0:0:6:0) ***Synchronous at 80.0 Mbyte/sec***, offset 127.
Vendor: QUANTUM Model: ATLAS10K2-TY184L Rev: DA40
Type: Direct-Access ANSI SCSI revision: 03
Detected scsi disk sda at scsi0, channel 0, id 6, lun 0
SCSI device sda: 35860910 512-byte hdwr sectors (18361 MB)
...
(My asterisks.)
Is this wrong, and can it be fixed, or am I just misunderstanding?
Thanks in advance,
Simon Garner
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
