Hi folks, I have a small query about the following scenario: 1) A READ(10) request is received by the queuecommand routine of a custom scsi driver. This driver is pesudo ie. does not drive any hardware, only passes CDB's to, & fro. 2) This CDB is sent to a standard linux scsi driver like eg. sym53c8xx via the sg interface. 3) The response(the partition-table contents in this case) is shipped back. 4) A kernel thread at the custom driver calls scsi_done. However, when the custom driver is unloaded immediately thereafter, scsi_unregister_host fails partway reporting the SCSI device is ``not inactive''. Why is there still a pending READ(10) in RQ_ACTIVE state despite step #4 above ? Any help would be greatly appreciated. Thank you, & regards, - varun - To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to [EMAIL PROTECTED]
